Search results
Results From The WOW.Com Content Network
Boundary microphone (Audio-Technica ATM87R) A boundary microphone (or pressure zone microphone) is one or more small omnidirectional or cardioid condenser mic capsule(s) positioned near or flush with a boundary (surface) such as a floor, table, or wall. The capsule(s) is/are typically mounted in a flat plate or housing.
50 to 15,000 Hz [9] Polar pattern Cardioid, [9] rotationally symmetrical about microphone axis, uniform with frequency Sensitivity (at 1,000 Hz Open Circuit Voltage) −54.5 dBV/Pa (1.85 mV); 1 Pa = 94 dB SPL [9] Impedance Rated impedance is 150 Ω (300 Ω actual) for connection to microphone inputs rated low impedance [9] Polarity
The Electro-Voice RE20 is an American professional cardioid dynamic microphone, commonly used in broadcasting applications since 1968. Designed by Electro-Voice using the company's patented Variable-D technology and a large-diaphragm element, it has been described as an industry standard "iconic" microphone for its natural sound and its wide ...
In 1959, another Shure engineer, Ernie Seeler, advanced the art of microphone design significantly with the Unidyne III capsule which was later used in the SM57. [1] After three years of research and development , which encompassed various torture tests, the result was the creation of the SM series of rugged and reliable Shure microphones. [ 1 ]
The directionality of the 77-DX is variable. A rotating backshutter on the acoustic labyrinth, controlled by a screwdriver-operated slot at the rear of the microphone, allows the user to vary the microphone's pattern from omnidirectional in the fully closed position, to cardioid, to figure-8 (bidirectional) in the fully open position.
The U47 was the first condenser microphone switchable between cardioid and omni-directional pick-up patterns. It incorporated the highly successful 12- micron -thick M7 capsule and VF-14 tube amplifier, which was a metal-clad pre-World War II pentode changed to work as a triode .
At a distance of about 50 cm (0.5 m) the time delay for a signal reaching first one and then the other microphone from the side is approximately 1.5 ms (1 to 2 ms). If the distance is increased between the microphones it effectively decreases the pickup angle.
English: A typical electret microphone preamp circuit uses a FET in a common source configuration. The two-terminal electret capsule contains an FET which must be externally powered by supply voltage V +. The resistor sets the gain and output impedance. The audio signal appears at the output, after a DC-blocking capacitor.