Ads
related to: how to calculate brake pressure sensor volvo d13 for sale
Search results
Results From The WOW.Com Content Network
The fault could be lack of hydraulic fluid, low brake fluid in the reservoir, a broken hydraulic line or a bad master brake cylinder. The sensor is used to detect pressure differentials in the hydraulic system. If the car alerts a fault in the hydraulic system and the system checks out, the sensor itself may have failed. [2]
The Sensotronic Brake Control (SBC) system operates using a hydraulic high-pressure reservoir to supply brake fluid. A piston pump, driven by an electric motor, generates controlled brake fluid pressure ranging between 140 bars (2,000 psi) and 160 bars (2,300 psi) in the gas diaphragm reservoir.
The B36 was discontinued in 1973, although it was no longer used in trucks after 1966. It was the last petrol truck engine built by Volvo and the only V8 engine used in any vehicle, except for the newer Yamaha-built units used in the Volvo XC90 and S80. A marine version, the Volvo Penta AQ180, was available, featuring 180 hp with twin carburetors.
The pressure of the rear wheels are approximated to the ideal brake force distribution in a partial braking operation. To do so, the conventional brake design is modified in the direction of rear axle overbraking, and the components of the ABS are used. EBD reduces the strain on the hydraulic brake force proportioning valve in the vehicle.
During the test, the computer measures the brake force values and the system will calculate the imbalance between the left and right brake forces of an axle, as well as the brake efficiency of the service brake and the parking brake provided that a vehicle weight is either inputted manually or by using an integrated weighing system. [2]
Despite having the dimension of pressure, MEP cannot be measured. [2] When quoted as an indicated mean effective pressure (IMEP), it may be thought of as the average pressure acting on a piston during the different portions of its cycle. When friction losses are subtracted from the IMEP, the result is the brake mean effective pressure (BMEP).
In a brake-by-wire car, some sensors are safety-critical components, and their failure will disrupt the vehicle function and endanger human lives. Two examples are the brake pedal sensors and the wheel speed sensors. The electronic control unit must always be informed of the driver's intentions to brake or to stop the vehicle. Therefore ...
The embedded sensor in the brake pad 2 contacts the rotor and creates a connection to ground of the sensor. The metal plate 3 contacts the rotor and creates a noise. This wear clip should be positioned so that the rotor contacts the clip before it contacts the brake pad. The rotor should push against that clip, not drag it away from the brake pad.