When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Flux linkage - Wikipedia

    en.wikipedia.org/wiki/Flux_linkage

    Thus, for a typical inductance (a coil of conducting wire), the flux linkage is equivalent to magnetic flux, which is the total magnetic field passing through the surface (i.e., normal to that surface) formed by a closed conducting loop coil and is determined by the number of turns in the coil and the magnetic field, i.e.,

  3. Coenergy - Wikipedia

    en.wikipedia.org/wiki/Coenergy

    If there is a finite change in flux linkage from one value to another (e.g. from to ), it can be calculated as: = () (If the changes are cyclic there will be losses for hysteresis and eddy currents. The additional energy for this would be taken from the input energy, so that the flux linkage to the coil is not affected by the losses and the ...

  4. Inductance - Wikipedia

    en.wikipedia.org/wiki/Inductance

    A coiled wire has a higher inductance than a straight wire of the same length, because the magnetic field lines pass through the circuit multiple times, it has multiple flux linkages. The inductance is proportional to the square of the number of turns in the coil, assuming full flux linkage.

  5. Direct torque control - Wikipedia

    en.wikipedia.org/wiki/Direct_torque_control

    Direct torque control (DTC) is one method used in variable-frequency drives to control the torque (and thus finally the speed) of three-phase AC electric motors.This involves calculating an estimate of the motor's magnetic flux and torque based on the measured voltage and current of the motor.

  6. Vector control (motor) - Wikipedia

    en.wikipedia.org/wiki/Vector_control_(motor)

    In vector control, an AC induction or synchronous motor is controlled under all operating conditions like a separately excited DC motor. [21] That is, the AC motor behaves like a DC motor in which the field flux linkage and armature flux linkage created by the respective field and armature (or torque component) currents are orthogonally aligned such that, when torque is controlled, the field ...

  7. Henry (unit) - Wikipedia

    en.wikipedia.org/wiki/Henry_(unit)

    The henry (symbol: H) is the unit of electrical inductance in the International System of Units (SI). [1] If a current of 1 ampere flowing through a coil produces flux linkage of 1 weber turn, that coil has a self-inductance of 1 henry.‌ The unit is named after Joseph Henry (1797–1878), the American scientist who discovered electromagnetic induction independently of and at about the same ...

  8. Glossary of electrical and electronics engineering - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_electrical_and...

    The SI unit of magnetic flux density. Tesla coil A kind of resonant transformer capable of very high voltages; almost identical to an Oudin coil except that it has separately wound primary and secondary. tetrode An electron device, nearly always a vacuum tube, with four internal active electrodes. thermionic emission

  9. Armature (electrical) - Wikipedia

    en.wikipedia.org/wiki/Armature_(electrical)

    The armature windings interact with the magnetic field (magnetic flux) in the air-gap; the magnetic field is generated either by permanent magnets, or electromagnets formed by a conducting coil. The armature must carry current , so it is always a conductor or a conductive coil, oriented normal to both the field and to the direction of motion ...