Search results
Results From The WOW.Com Content Network
NAT hairpinning, also known as NAT loopback or NAT reflection, [27] is a feature in many consumer routers [28] where a machine on the LAN is able to access another machine on the LAN via the external IP address of the LAN/router (with port forwarding set up on the router to direct requests to the appropriate machine on the LAN).
Section Configuring Web Cache Services Using WCCP in the "Cisco IOS Configuration Fundamentals Configuration Guide, Release 12.2" Section WCCPv2 and WCCP Enhancements in the feature guide for "Cisco IOS Software Releases 12.0 S" Configure WCCP on your Cisco IOS router on TechRepublic; Web Cache Communication Protocol V2, revision 1 on IETF Web Site
NOTE: a RID is the highest logical (loopback) IP address configured on a router, if no logical/loopback IP address is set then the router uses the highest IP address configured on its active interfaces (e.g. 192.168.0.1 would be higher than 10.1.1.2). Usually the router with the second-highest priority number becomes the BDR.
Link-local addresses may be assigned manually by an administrator or by automatic operating system procedures. In Internet Protocol (IP) networks, they are assigned most often using stateless address autoconfiguration, a process that often uses a stochastic process to select the value of link-local addresses, assigning a pseudo-random address that is different for each session.
Ethernet Configuration Testing Protocol is a diagnostic protocol included in the Xerox Ethernet II specification. [1] Functionality of the protocol is similar to that offered by ping but it operates at the data link layer as opposed to the network layer. Ethernet Configuration Testing Protocol was implemented on DEC hosts and Cisco routers. [2]
Network address translation typically uses private IP addresses on private networks with a single public IP address for the router facing the Internet.The network address translator changes the source address in network protocols for outgoing requests from that of an internal device to its external address, so that internal devices can communicate with hosts on the external network, while ...
Port triggering is a configuration option on a NAT-enabled router that controls communication between internal and external host machines in an IP network. It is similar to port forwarding in that it enables incoming traffic to be forwarded to a specific internal host machine, although the forwarded port is not open permanently and the target internal host machine is chosen dynamically.
Router configuration rules may contain static routes. A static route minimally has a destination address, a prefix length or subnet mask, and a definition where to send packets for the route. That definition can refer to a local interface on the router, or a next-hop address that could be on the far end of a subnet to which the router is connected.