Search results
Results From The WOW.Com Content Network
Some new cranes have a 120-tonne load capacity, enabling them to lift up to four 20-foot (6.1 m) or two 40-foot (12 m) containers. Cranes capable of lifting six 20-foot containers have also been designed. Post-Panamax cranes weigh approximately 800–900 tonnes, while the newer-generation super-post-Panamax cranes can weigh 1,600–2,000 tonnes.
The XGC88000 crawler crane, unlike the majority of crawler cranes, comes in two sections. The primary section consists of the crane itself, which boasts a maximum boom length of 144 meters, a maximum total length of 173 meters (including the counterweight radius), a maximum height (when fully erect) of 108 meters, a lifting capacity ranging between 3,600 and 4,000 tons [10] [11] [12] (although ...
A crane's rated load is its Safe Working Load (SWL) and the design load (DL) is, (p 90) [1] = The dynamic lift factor for offshore cranes in the range 10 kN < SWL ≤ 2500 kN is not less than =.(p 84) [1] Thus for a crane with a SWL of 2000 kN (~200 tonne) its design load is not less than, = = The minimum breaking load (MBL) for the combined capacity of reeves of a steel wire hoisting rope ...
A simple crane. A counterweight is a weight that, by applying an opposite force, provides balance and stability of a mechanical system. [1] The purpose of a counterweight is to make lifting the load faster and more efficient, which saves energy and causes less wear and tear on the lifting machine.
Generally, these cranes are able to travel on highways, eliminating the need for special equipment to transport the crane unless weight or other size constrictions are in place such as local laws. If this is the case, most larger cranes are equipped with either special trailers to help spread the load over more axles or are able to disassemble ...
An overhead crane, commonly called a bridge crane, is a type of crane found in industrial environments. An overhead crane consists of two parallel rails seated on longitudinal I-beams attached to opposite steel columns by means of brackets. The traveling bridge spans the gap. A hoist, the lifting component of a crane, travels along the bridge.
The Bagger 288 bucket-wheel excavator, beside a Caterpillar Inc. model 824H front end loader for size comparison The excavating head itself is 21.6 m (70 ft 10 in) in diameter and has 18 buckets each holding 6.6 cubic metres (8.6 cu yd) of overburden.
In 1959 crane expert R.H.Neal, hydraulics specialist F.Taylor, and design director Bob Lester, integrated all three and modernized cranes. The Coles Hydra Speedcrane appeared in 1962, further modified with the 10-ton fully telescopic hydraulic boom in 1966, followed in 1968 by the 30-ton "Husky" military versions with four-wheel drive .