Ads
related to: waterproof coating for osb sheathing cost- Moisture Barrier Install
Keep Your Basement Dry
Fast Installation by Local Pros
- Waterproofing Pros
Affordable Solutions & Options
A Dry Basement You Can Afford
- Exterior Waterproofing
Stop Foundation Leaks Now
Keep Water Outside
- Waterproofing Inspection
Get Immediate Advice & Stop Leaks
Years of Experience Trust the Pros
- Moisture Barrier Install
Search results
Results From The WOW.Com Content Network
Oriented strand board (OSB) is a type of engineered wood, formed by adding adhesives and then compressing layers of wood strands (flakes) in specific orientations. It was invented by Armin Elmendorf in California in 1963. [ 1 ]
These were the forerunners of the present asphalt and coal-tar-pitch built-up roofs. It is not known definitely when felt was first substituted for sheathing paper or when asphalt was first used as the impregnating agent, but it is known that the first asphalt-prepared roofing, that is, roofing manufactured ready to apply, was marketed in 1893.
Bituminous waterproofing systems are designed to protect residential and commercial buildings. Bitumen (asphalt or coal-tar pitch) is a material made up of organic liquids that are highly sticky, viscous , and waterproof. [ 1 ]
In the United States, the International Building Code and ASTM International define Exterior Insulation and Finish System (EIFS) as a non-load-bearing exterior wall cladding system that consists of an insulation board attached either adhesively, mechanically, or both, to the substrate; an integrally reinforced base coat; and a textured protective finish coat.
Plywood and OSB typically have a density of 560–640 kg/m 3 (35–40 lb/cu ft). For example, 9.5 mm (3 ⁄ 8 in) plywood sheathing or OSB sheathing typically has a surface density of 4.9–5.9 kg/m 2 (1–1.2 lb/sq ft). [51] Many other engineered woods have densities much higher than OSB.
Standard OSB with EPS-core structural insulated panel. Although foam-core panels gained attention in the 1970s, the idea of using stress-skinned panels for construction began in the 1930s.