Ad
related to: factory acceptance testing examples
Search results
Results From The WOW.Com Content Network
Typical types of acceptance testing include the following User acceptance testing This may include factory acceptance testing (FAT), i.e. the testing done by a vendor before the product or system is moved to its destination site, after which site acceptance testing (SAT) may be performed by the users at the site. [21] Operational acceptance testing
Typically, a supplier performs the FAI and the purchaser reviews the report. The FAI process usually consists of fully testing and inspecting either the first part produced by the new process or a sample from the first batch of parts. First article inspection is typically a purchase order requirement of the purchaser for the supplier to complete.
In general, acceptance sampling is employed when one or several of the following hold: [2] testing is destructive; the cost of 100% inspection is very high; and; 100% inspection takes too long. A wide variety of acceptance sampling plans is available. For example, multiple sampling plans use more than two samples to reach a conclusion.
Operational testing a jet engine. Operational acceptance testing (OAT) is used to conduct operational readiness (pre-release) of a product, service, or system as part of a quality management system. OAT is a common type of non-functional software testing, used mainly in software development and software maintenance projects. This type of ...
A dry run (or practice run) is a software testing process used to make sure that a system works correctly and will not result in severe failure. [1] For example, rsync, a utility for transferring and synchronizing data between networked computers or storage drives, has a "dry-run" option users can use to check that their command-line arguments are valid and to simulate what would happen when ...
Development, testing, acceptance and production (DTAP) [1] [2] is a phased approach to software testing and deployment. The four letters in DTAP denote the following common steps: Development: The program or component is developed on a development system. This development environment might have no testing capabilities.
Verification is intended to check that a product, service, or system meets a set of design specifications. [6] [7] In the development phase, verification procedures involve performing special tests to model or simulate a portion, or the entirety, of a product, service, or system, then performing a review or analysis of the modeling results.
Conformance testing — an element of conformity assessment, and also known as compliance testing, or type testing — is testing or other activities that determine whether a process, product, or service complies with the requirements of a specification, technical standard, contract, or regulation.