Search results
Results From The WOW.Com Content Network
STP will select the path with the lowest cost, that is the highest bandwidth, as the preferred link. STP will enable this preferred link as the only path to be used for Ethernet frames between the two switches, and disable all other possible links by designating the switch ports that connect the preferred path as root port .
MSTP is designed to be STP and RSTP compatible and interoperable without additional operational management practice, this is due to a set of measurements based on RSTP (Clause 17 of IEEE Std 802.1D, 2004 Edition) intending to provide the capability for frames assigned to different VLANs, to be transmitted along different paths within MST Regions.
The term sewage treatment plant (STP) (or sewage treatment works) is nowadays often replaced with the term wastewater treatment plant (WWTP). [7] [8] Strictly speaking, the latter is a broader term that can also refer to industrial wastewater treatment. The terms water recycling center or water reclamation plants are also in use as synonyms.
A general note applies generally and is not called out with flags. 2. Find number: "FN" meaning "find number" refers to the ordinal number that gives an ID tag to one of the constituents in a parts list (list of materials, bill of materials). Thus "fasten using FN7" refers to a fastener that is "find number" 7 in the list. FoS: feature of size
Symbol used in drawings Standard penetration test N values from a surficial aquifer in south Florida.. The standard penetration test (SPT) is an in-situ dynamic penetration test designed to provide information on the geotechnical engineering properties of soil.
A bonded twisted pair is a construction variant in which the two wires of each pair are bonded together for the length of the cable. Pioneered by Belden , it is intended to help assure configuration consistency during and after installation.
Until 1982, STP was defined as a temperature of 273.15 K (0 °C, 32 °F) and an absolute pressure of exactly 1 atm (101.325 kPa). Since 1982, STP has been defined as a temperature of 273.15 K (0 °C, 32 °F) and an absolute pressure of exactly 1 bar (100 kPa, 10 5 Pa).
References to the construction documents, drawings, and specifications assist the architect and engineer in their review of the shop drawings. Attachment of manufacturer’s material specifications, “catalog cut sheets,” and other manufacturer’s information may be helpful to accompany these drawings.