Search results
Results From The WOW.Com Content Network
Engine regulations vary between clubs, but these are standard lawn mower-type engines with little or no modification or tuning. Given the right track conditions, mowers can reach speeds of up to 50 mph although track design serves to limit this and ensure that driver skill remains an important element of the sport.
The D-400 series engine or the Iron Horse engine was a light-duty two-stroke engine used for powering lawnmowers produced from the 1950s to the late 1970s. D-400 engines were single-cylinder engines designed and manufactured by the Outboard Marine Corporation (OMC; Johnson and Evinrude) for Lawn-Boy [2] and Masport. The D-400 engines displaced ...
Lap joints can be used to join wood, plastic, or metal. A lap joint can be used in woodworking for joining wood together. A lap joint may be a full lap or half lap. In a full lap, no material is removed from either of the members that will be joined, resulting in a joint which is the combined thickness of the two members.
A knuckle joint on a locomotive, seen behind the pin joint of the eccentric crank. Ball-point pen included for size. A mechanical joint is a section of a machine which is used to connect one or more mechanical parts to another. Mechanical joints may be temporary or permanent; most types are designed to be disassembled.
The combustion cycle can be either two-stroke (which results in a lighter engine for a given power output) [3] [4] or four-stroke (which produce lower levels of exhaust gas emissions). [5] [6] The fuel is usually either petrol or diesel. [7] In 1973, a small Wankel (rotary) engine manufactured by NSU was used in a lawn mower. [8]
This tractor had eight speeds, with four speeds each in low and high range, with engine options ranging from a cast-iron 10 horsepower Kohler single-cylinder, to an 18-horsepower cast-aluminum twin-cylinder Onan. The 800 series was replaced with the 8000 series by 1978, which offered more powerful engine configurations and an improved hydraulic ...
This drive system can be used on two types of zero-turn mowers: Mid mount, where the mower is suspended under a 4-wheel chassis, with front caster wheels and rear drive wheels; Out front, where the mower is front-mounted and thus terrain following, providing a higher level of balance, comfort, safety and performance. The Out-front models use a ...
There are many types of butt welds, but all fall within one of these categories: single-welded butt joints, double-welded butt joint, and open or closed butt joints. A single welded butt joint is the name for a joint that has only been welded from one side. A double-welded butt joint is created when the weld has been welded from both sides.