When.com Web Search

  1. Ads

    related to: 2 way indoor amplifier splitter antenna for home phone

Search results

  1. Results From The WOW.Com Content Network
  2. Cellular repeater - Wikipedia

    en.wikipedia.org/wiki/Cellular_repeater

    A cellular repeater (also known as cell phone signal booster or cell phone signal amplifier) is a type of bi-directional amplifier used to improve cell phone reception. [citation needed] A cellular repeater system commonly consists of a donor antenna that receives and transmits signal from nearby cell towers, coaxial cables, a signal amplifier, and an indoor rebroadcast antenna.

  3. Power dividers and directional couplers - Wikipedia

    en.wikipedia.org/wiki/Power_dividers_and...

    In figure 21, an example is shown of a signal split up to feed multiple low power amplifiers, then recombined to feed a single antenna with high power. [52] Figure 21. Splitter and combiner networks used with amplifiers to produce a high power 40 dB (voltage gain 100) solid state amplifier Figure 22. Phase arrangement on a hybrid power combiner.

  4. Diplexer - Wikipedia

    en.wikipedia.org/wiki/Diplexer

    The dish antenna occupies the high frequencies (typically 950 to 1450 MHz), and the TV antenna uses lower television channel frequencies (typically 50 to 870 MHz). In addition, the satellite also gets a DC to low frequency band to power the dish's block converter and select the dish antenna polarization (e.g., voltage signaling or DiSEqC ).

  5. Home wiring - Wikipedia

    en.wikipedia.org/wiki/Home_wiring

    RF splitters come with different types; some include amplifiers for multiple outlets. Whilst most TV outlets use the F connector the Television or digital set top box usually come with a connector known as Belling Lee so the cable used to connect from the TV outlet to the television will need to have an F connector in one end and a Belling Lee ...

  6. Distributed antenna system - Wikipedia

    en.wikipedia.org/wiki/Distributed_antenna_system

    A single antenna radiating at high power (a) is replaced by a group of low-power antennas to cover the same area (b). The idea was described in a paper by Saleh et al. [2] in 1987. These antennas have recently been employed by several service providers in many areas around the United States.

  7. Antenna types - Wikipedia

    en.wikipedia.org/wiki/Antenna_types

    This antenna radiates maximally in directions perpendicular to the antenna's axis, giving it a small directive gain of 2.15 dBi (2.15 dBi means that in the direction of maximum radiation, signal strength is 1.64× the signal from a directionless "isotropic" antenna).