Search results
Results From The WOW.Com Content Network
A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick 3300/3800 V6; Cadillac HT4100/4.5/4.9 L V8; Isuzu all 3.2 and 3.5L DOHC V6
1.2/1.3/1.5/1.7L were mostly in European Cars. 1.8, 2.0/2.3 had the same bellhousings bolt patterns with differences from year to year to be wary of. The Mazda transmission 5M** does not "directly replace" the Mitsubishi transmissions as there are shifter spacing differences in the floorboard.
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
The LE9 5.0 L (305 cu in) was a version of the 305 with a four-barrel 650 cu ft/min (18 m 3 /min) carburetor and equipped with electronic spark control (ESC), [34] a 9.2-9.5:1 compression ratio, the LM1 cam and 14010201 casting heads featuring 1.84/1.50" valves, and 53 cc (3.2 cu in) chambers. The engine produced 165 hp (123 kW) at 4,400 and ...
The Lincoln LS is a four-door, five-passenger luxury sedan manufactured and marketed by Ford's Lincoln division over a single generation from 1999 until 2006. Introduced in June 1999 for the 2000 model year, the LS featured rear-wheel drive and near 50/50 weight distribution [1] and was available with a V8 or V6, the latter initially offered with a manual transmission.
A Hydra-Matic 4L80 transmission at the Ypsilanti Automotive Heritage Museum. The 4L80-E (RPO MT1) is rated to handle engines with up to 440 ft·lbf (597 N·m) of torque. [2] The 4L80-E is rated to a maximum GVWR of 18,000 lb, depending on the axle and vehicle. [3]
Displacement is 5,327 cc (5.3 L; 325.1 cu in) from a bore and stroke of 96 mm × 92 mm (3.78 in × 3.62 in). Vortec 5300s were built in St. Catharines, Ontario , and Romulus, Michigan . The aluminum block variants, the LM4 and the L33, share the same displacement, but instead use an aluminum block with cast-in cylinder liners, much like the LS1.
The L-carrier system was one of a series of carrier systems developed by AT&T for high-capacity transmission for long-distance communications. Over a period from the late 1930s to the 1970s, the system evolved in six significant phases of development, designated by Bell System engineers as L-1 through L-5, and L-5E.