Ads
related to: 2 meter dipole antenna construction
Search results
Results From The WOW.Com Content Network
The bow-tie antenna is a dipole with flaring, triangular shaped arms. The shape gives it a much wider bandwidth than an ordinary dipole. It is widely used in UHF television antennas. Cage dipole antennas in the Ukrainian UTR-2 radio telescope. The 8 m by 1.8 m diameter galvanized steel wire dipoles have a bandwidth of 8–33 MHz.
Moxon antenna for the 20-meter band.The antenna is the faint rectangle of wires held in tension by the bent X-shaped support frame. Moxon antenna for the 2-meter band. The Moxon antenna or Moxon rectangle is a simple and mechanically rugged two-element parasitic array, single-frequency antenna. [1]
Inverted-'V' antenna When the two arms of a dipole are individually straight, but bent towards each other in a 'V' shape, at an angle noticeably less than 180°, the dipole is called a 'V' antenna, and when the dipole arms' end closer to the ground than their center branch-point, the antenna is called an inverted-'V' . The inverted-'V' is ...
The most common form of log-periodic antenna is the log-periodic dipole array or LPDA, The LPDA consists of a number of half-wave dipole driven elements of gradually increasing length, each consisting of a pair of metal rods.
A mast radiator or mast antenna is a radio tower or mast in which the whole structure is an antenna. Mast antennas are the transmitting antennas typical for long or medium wave broadcasting. Structurally, the only difference is that some mast radiators require the mast base to be insulated from the ground.
A halo antenna, or halo, is a center-fed 1 / 2 wavelength dipole antenna, which has been bent into a circle, with a break directly opposite the feed point. The dipole's ends are close, but do not touch, and the ends on either side of the gap may be flared out to form a larger air gap capacitor , whose spacing is used to fine-adjust the ...
The addition of parasitic elements gives a diminishing improvement in the antenna's gain. [2] Adding a reflector to a dipole, to make a 2 element Yagi, increases the gain by about 5 dB over the dipole. Adding a director to this, to give a 3 element Yagi, gives a gain of about 7 dB over a dipole.
The antenna was a cylindrical parabolic reflector made of zinc sheet metal supported by a wooden frame, and had a spark-gap excited 26 cm dipole as a feed antenna along the focal line. Its aperture was 2 meters high by 1.2 meters wide, with a focal length of 0.12 meters, and was