Search results
Results From The WOW.Com Content Network
At high frequencies, the PIN diode appears as a resistor whose resistance is an inverse function of its forward current. Consequently, PIN diode can be used in some variable attenuator designs as amplitude modulators or output leveling circuits. PIN diodes might be used, for example, as the bridge and shunt resistors in a bridged-T attenuator.
An example is given in the section below on electroacoustics. Sensitivity second definition: the minimum magnitude of input signal required to produce an output signal with a specified signal-to-noise ratio of an instrument or sensor. Examples of the use of this definition are given in the sections below on receivers and electronic sensors.
Design of a PSD using a PIN diode. The technical term PSD was first used in a 1957 publication by J.T. Wallmark for lateral photoelectric effect used for local measurements. On a laminar semiconductor, a so-called PIN diode is exposed to a tiny spot of light. This exposure causes a change in local resistance and thus electron flow in four ...
Not to be confused with Printed electronics. "PC board" redirects here. For the mainboard of personal computers, see Motherboard. "Panelization" redirects here. For the page layout strategy, see N-up. Printed circuit board of a DVD player Part of a 1984 Sinclair ZX Spectrum computer board, a printed circuit board, showing the conductive traces, the through-hole paths to the other surface, and ...
[citation needed] For example, the internal structure of an NPN bipolar transistor resembles two P-N junction diodes connected together by a common anode. In normal operation the base-emitter junction does indeed form a diode, but in most cases it is undesirable for the base-collector junction to behave as a diode.
In photoconductive mode the diode is reverse biased, that is, with the cathode driven positive with respect to the anode. This reduces the response time because the additional reverse bias increases the width of the depletion layer, which decreases the junction's capacitance and increases the region with an electric field that will cause ...
The pentode, as introduced by Tellegen, has an additional electrode, or third grid, called the suppressor grid, located between the screen grid and the anode, which solves the problem of secondary emission. The suppressor grid is given a low potential—it is usually either grounded or connected to the cathode.
Care must be taken with glass diodes which are less mechanically robust than resistors and other MELF components. Also, when building up PCBs via manual assembly using tweezers (e.g., for prototyping) then the pressure at the end of tweezers can often cause a MELF component to slip and shoot out the ends, thereby making their placement more ...