Search results
Results From The WOW.Com Content Network
The inductive output tube (IOT) or klystrode is a variety of linear-beam vacuum tube, similar to a klystron, used as a power amplifier for high frequency radio waves. It evolved in the 1980s to meet increasing efficiency requirements for high-power RF amplifiers in radio transmitters. [ 1 ]
The television broadcast bands are too wide in frequency to be covered by a single antenna, so the two options are separate antennas used for the VHF and UHF bands or a combination (combo) VHF/UHF antenna. [6] A VHF/UHF antenna combines two antennas feeding the same feedline mounted on the same support boom.
LNA-100 Boost Antenna Amplifier. If you’re looking for an antenna amplifier that's easy to set up and minimizes wires in your house, the Winegard LNA-100 Boost is an ideal choice.
When the TV is tuned to the programmed channel, the video and audio signal of the source device is accessed. RF modulation can become difficult in a CATV system. High pass, low pass, and notch filters must be used to block certain frequencies, or channels, so that the modulator can broadcast the audio/video signal of the source device on that ...
HTV2, a television channel, was launched on October 10, 2003, as an experimental broadcast on channel 30 UHF. It was accompanied by channels HTV1 and HTV3, and initially aired for nine hours a day. However, starting from November 1, 2003, HTV2 officially extended its broadcast hours to run from 6 am to 24 hours daily. The channel is owned by HTV.
The IF amplifiers are centered at 44 MHz for optimal frequency transference of the audio and video carriers. [k] Like radio, television has automatic gain control (AGC). This controls the gain of the IF amplifier stages and the tuner. The video amp and output amplifier is implemented using a pentode or a power transistor. The filter and ...
Older TV installations may use a solid dielectric RG-59 cable, and that cable may be inadequate. [1] RG-6 cable is typically used for satellite feed lines. In this application, there would be a diplexer on the roof that joins the satellite dish feed and the TV antenna together into a single coaxial cable.
A standard rack-mount headend. Once a television signal is received, it must be processed. For digital satellite TV signals, a dedicated commercial satellite receiver is needed for each channel that is to be distributed by the cable system; these are usually rack-mountable receivers that are designed to take up less space than consumer receivers.