Search results
Results From The WOW.Com Content Network
Atmospheric air pressure where standard atmospheric pressure is defined as 1013.25 mbar, 101.325 kPa, 1.01325 bar, which is about 14.7 pounds per square inch. Despite the millibar not being an SI unit, meteorologists and weather reporters worldwide have long measured air pressure in millibar as the values are convenient.
Atmospheric pressure, also known as air pressure or barometric pressure (after the barometer), is the pressure within the atmosphere of Earth.The standard atmosphere (symbol: atm) is a unit of pressure defined as 101,325 Pa (1,013.25 hPa), which is equivalent to 1,013.25 millibars, [1] 760 mm Hg, 29.9212 inches Hg, or 14.696 psi. [2]
The units of atmospheric pressure commonly used in meteorology were formerly the bar (100,000 Pa), which is close to the average air pressure on Earth, and the millibar. Since the introduction of SI units , meteorologists generally measure atmospheric pressure in hectopascals (hPa), equal to 100 pascals or 1 millibar.
= molar mass of Earth's air: 0.0289644 kg/mol The value of subscript b ranges from 0 to 6 in accordance with each of seven successive layers of the atmosphere shown in the table below. The reference value for ρ b for b = 0 is the defined sea level value, ρ 0 = 1.2250 kg/m 3 or 0.0023768908 slug/ft 3 .
When these fluctuations were explained as a manifestation of changes in atmospheric pressure, the science of meteorology was born. Over time, 760 millimeters of mercury at 0 °C came to be regarded as the standard atmospheric pressure. In honour of Torricelli, the torr was defined as a unit of pressure equal to one millimeter of mercury at 0 °C.
For gases, pressure is sometimes measured not as an absolute pressure, but relative to atmospheric pressure; such measurements are called gauge pressure. An example of this is the air pressure in an automobile tire, which might be said to be "220 kPa (32 psi)", but is actually 220 kPa (32 psi) above atmospheric pressure. Since atmospheric ...
The standard atmosphere was originally defined as the pressure exerted by a 760 mm column of mercury at 0 °C (32 °F) and standard gravity (g n = 9.806 65 m/s 2). [2] It was used as a reference condition for physical and chemical properties, and the definition of the centigrade temperature scale set 100 °C as the boiling point of water at this pressure.
Use of the kilogram-force per square centimetre continues primarily due to older pressure measurement devices still in use. This use of the unit of pressure provides an intuitive understanding for how a body's mass, in contexts with roughly standard gravity, can apply force to a scale's surface area, i.e. kilogram-force per square (centi-)metre.