Ads
related to: flexiride torsion axle 3500 lbs 2
Search results
Results From The WOW.Com Content Network
However, the 10.5" 14-bolt axle remains in production today, specifically utilized in GMC Savana and Chevrolet Express vans. Notably, the 11.5" 14-bolt axle is featured in third-generation Dodge Ram 2500 and 3500 trucks. There are discernible differences between the GM and Ram versions, evident in the gaskets used and the axle cover designs.
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.
The Dana Holding Corporation manufactured the TTB axle for Ford. It uses a universal joint in the center that allows the wheels to move independently of each other. The differential is offset to the driver's side, and a slip yoke is used on the long axle side to allow the shaft to change length.
The Dana 80 Trac Lok is unique being it is a 4 pinion unit, unlike other Dana Trac Lok units with 2 pinions. This was the only rear axle available for the 2nd generation Dodge Ram 3500 trucks. [2] 35 Spline Dana 80 in a 2002 Dodge 2500HD Diesel
The Dana 61 was made in semi-float and full-float axles for select 4×2 and 4x4 Ford 3 ⁄ 4-ton and 1 Ton Pickups and Vans from 1974 to 1987. A Dana 61 front axle was selectively used in Dodge 4×4 3 ⁄ 4-ton and 1 Ton pickups from 1987 to 1993. Although 3.07:1 and 3.31:1 gear sets are common for a Dana 61, lower gear sets deeper than (4.10:1 ...
De Dion rear axle. A de Dion axle is a form of non-independent automobile suspension. It is a considerable improvement over the swing axle, Hotchkiss drive, or live axle. [1] Because it plays no part in transmitting power to the drive wheels, it is sometimes called a "dead axle". [2]
Ad
related to: flexiride torsion axle 3500 lbs 2