Search results
Results From The WOW.Com Content Network
Pipeline-quality gas has an energy value slightly higher than that of pure methane, which has 10.47 kilowatt-hours per cubic metre (1,012 British thermal units per cubic foot). Natural gas as it comes out of the ground is most often predominantly methane, but may have a wide range of energy values, from much lower (due to dilution by non ...
A standard cubic foot (scf) is a unit representing the amount of gas (such as natural gas) contained in a volume of one cubic foot at reference temperature and pressure conditions. It is the unit commonly used when following the customary system , a collection of standards set by the National Institute of Standards and Technology .
The calorific value of manufactured gas is around 500 Btu per cubic foot (18,629 kJ/m 3). Whereas, the calorific value of natural gas is twice that at around 1000 Btu per cubic foot (37,259 kJ/m 3). [3] For a given amount of heat only half the volume of natural gas is required.
The Wobbe index is expressed in MJ/Nm³ (where 'Nm³' indicates'm³ in Normal conditions), or sometimes in BTU/scf.In the case of natural gas (molar mass 17 g/mol), the typical heating value is around 39 MJ/Nm³ (1,050 BTU/scf) and the specific gravity is approximately 0.59, giving a typical Wobbe index of 51 MJ/Nm³ (1,367 BTU/scf).
The price of natural gas varies greatly depending on location and type of consumer. The typical caloric value of natural gas is roughly 1,000 BTU per cubic foot, depending on gas composition. Natural gas in the United States is traded as a futures contract on the New York Mercantile Exchange. Each contract is for 10,000 million BTU or 10 ...
When positive pressure is applied to a standard cubic foot of gas, it is compressed. When a vacuum is applied to a standard cubic foot of gas, it expands. The volume of gas after it is pressurized or rarefied is referred to as its "actual" volume. SCF and ACF for an ideal gas are related in accordance with the combined gas law: [2] [3]
The lower heating value of natural gas is normally about 90% of its higher heating value. This table is in Standard cubic metres (1 atm, 15 °C), to convert to values per Normal cubic metre (1 atm, 0 °C), multiply above table by 1.0549.
p is the gas pressure; R is the gas constant, T is temperature, V m is the molar volume (V/n), a is a constant that corrects for attractive potential of molecules, and; b is a constant that corrects for volume. The constants are different depending on which gas is being analyzed. The constants can be calculated from the critical point data of ...