Ads
related to: ohmmeter circuit
Search results
Results From The WOW.Com Content Network
An analog ohmmeter. An ohmmeter is an electrical instrument that measures electrical resistance (the opposition offered by a circuit or component to the flow of electric current). Multimeters also function as ohmmeters when in resistance-measuring mode. An ohmmeter applies current to the circuit or component whose resistance is to be measured.
Ohmmeter: Measures the resistance of a component Oscilloscope: Displays waveform of a signal, allows measurement of frequency, timing, peak excursion, offset, ... Psophometer: Measures AF signal level and noise Q meter: Measures Q factor of the RF circuits Tachometer: Measures speed of motors Signal analyzer
One of the functions of many types of multimeters is the measurement of resistance in ohms.. The ohm is defined as an electrical resistance between two points of a conductor when a constant potential difference of one volt (V), applied to these points, produces in the conductor a current of one ampere (A), the conductor not being the seat of any electromotive force.
Megohmmeter M1101M. A Megohmmeter or insulation resistance tester, is a special type of ohmmeter used to measure the electrical resistance of insulators. [1] Insulating components, for example cable jackets, must be tested for their insulation strength at the time of commissioning and as part of maintenance of high voltage electrical equipment and installations.
An ohmmeter could be used to verify this value. Substances in which electricity can flow are called conductors. A piece of conducting material of a particular resistance meant for use in a circuit is called a resistor. Conductors are made of high-conductivity materials such as metals, in particular copper and aluminium. Resistors, on the other ...
Power off testing includes analog signature analysis, ohmmeter, LCR Meter and optical inspection. This type of testing also lends itself well to troubleshooting circuit boards without the aid of supporting documentation such as schematics.
Ohmmeter (Measures resistance) Ammeter, e.g. Galvanometer or Milliammeter (Measures current) Multimeter e.g., VOM (Volt-Ohm-Milliammeter) or DMM (Digital Multimeter) (Measures all of the above) LCR meter - inductance (L), capacitance (C) and resistance (R) meter (measure LCR values) The following are used for stimulus of the circuit under test:
Some measurements in signal circuits require higher sensitivity movements so as not to load the circuit under test with the meter impedance. [ 42 ] [ 43 ] Sensitivity should not be confused with resolution of a meter, which is defined as the lowest signal change (voltage, current, resistance and so on) that can change the observed reading.