Ads
related to: akai vacuum tube receiver reviewsweetwater.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
Collins S-Line, featuring separate power supply, receiver, transmitter, and speaker console, c. 1960s. Amateur radio equipment of past eras like the 1940s, 50s, and 60s that are separate vacuum tube transmitters and receivers (unlike modern transceivers) are an object of nostalgia, and many see rehabilitation and on-air use by enthusiasts. [18 ...
This led to development of always-on preheating systems for vacuum tube appliances that shortened the wait and may have reduced valve failures from thermal shock, but at the price of a continuous power drain, and an increased fire hazard. On the other hand, very small, ultra low power direct-heated valves turn on in tenths of a second from a ...
The term All American Five (abbreviated AA5) is a colloquial name for mass-produced, superheterodyne radio receivers that used five vacuum tubes in their design. These radio sets were designed to receive amplitude modulation (AM) broadcasts in the medium wave band, and were manufactured in the United States from the mid-1930s until the early 1960s.
A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.
Most radios used vacuum tube batteries until the mid to late 1920s. [1] The line-operated vacuum tube receiver was invented in 1925 by Edward S. Rogers, Sr. The unit operated with five Rogers AC vacuum tubes and the Rogers Battery-Eliminator Power Unit (power supply). This unit was later marketed for $120 [2] as "Type 120".
A high vacuum tube needs a gridleak resistor parallel to the gridleak capacitor. In Fig. 3, the LC circuit L and C select the receiver frequency. C2 is the gridleak capacitor and helps to demodulate the received signal. B1 is the A-battery or heater battery and B2 is the B-battery or anode battery. In Fig. 8, L, C, B1 and B2 are as in Fig. 3.