When.com Web Search

  1. Ads

    related to: well foot valve not working properly

Search results

  1. Results From The WOW.Com Content Network
  2. Bailer (hydrogeology) - Wikipedia

    en.wikipedia.org/wiki/Bailer_(hydrogeology)

    Also, if there is a high amount of sediment or turbidity, this may interfere with the ball check valve seating correctly. A basic disposable bailer can also be used as the slug in a Slug test to remove water from the well. This is sometimes referred to more specifically as the bail-down test.

  3. Drain-waste-vent system - Wikipedia

    en.wikipedia.org/wiki/Drain-waste-vent_system

    A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

  4. Well control - Wikipedia

    en.wikipedia.org/wiki/Well_control

    The LOT determines the pressure and/or fluid weight the test zone below the casing can sustain. The fluid in the well must be circulated clean to ensure it is of a known and consistent density. If mud is used, it must be properly conditioned and gel strengths minimized. The pump used should be a high-pressure, low-volume test, or cementing pump.

  5. Downhole safety valve - Wikipedia

    en.wikipedia.org/wiki/Downhole_safety_valve

    This means that they are installed as a component of the completion string and run in during completion. Retrieving the valve, should it malfunction, requires a workover. The full name for this most common type of downhole safety valve is a Tubing Retrievable Surface Controlled Sub-Surface Valve, shortened in completion diagrams to TRSCSSV.

  6. Reduced pressure zone device - Wikipedia

    en.wikipedia.org/wiki/Reduced_pressure_zone_device

    This gauge uses hoses attached to the various test cocks of the RPZD and checks to be certain that the check valve springs as well as the relief valve spring are not fouled and are working properly. There is a variety of manufacturers of these gauges, but most utilize either a three-valve or a five-valve design to test the RPZD in different ways.

  7. Oil well control - Wikipedia

    en.wikipedia.org/wiki/Oil_well_control

    As technology has advanced, more modern drillers have better control of the overall well. Oil well control is the management of the dangerous effects caused by the unexpected release of formation fluid, such as natural gas and/or crude oil, upon surface equipment of oil or gas drilling rigs and escaping into the atmosphere.