Ads
related to: 1 2 inch exterior plywood
Search results
Results From The WOW.Com Content Network
[citation needed] At 3 ⁄ 8 inch (9.5 mm) thick, mahogany three-ply "wiggle board" or "bendy board" come in 4 by 8 feet (1.2 m × 2.4 m) sheets with a very thin cross-grain central ply and two thicker exterior plies, either long grain on the sheet, or cross grain. Wiggle board is often glued together in two layers once it is formed into the ...
Homasote is used in theatrical sets as a noise deadening layer for stage platforms consisting of a 3 ⁄ 4-inch (19 mm) plywood sublayer, a 1 ⁄ 2-inch (13 mm) Homasote layer, and a 1 ⁄ 4-inch (6 mm) Masonite top layer.
Medium density overlay panel, or MDO panel, is a paintable surface made of plywood with a weather-resistant resin overlay bonded to the wood by heat and pressure. The overlay, which has at least 27% resin content, [1] resists water, weather, wear and degradation. A similar product with a more rugged, smoother surface is called high density ...
The boards are laid out on edge on the shop floor, the ends are glued together and stapled or screwed. Keystones and corner blocks are not normally used. Once assembled, the flat can be covered with 1 ⁄ 4-inch (6.4 mm) or 1 ⁄ 8-inch (3.2 mm) decorative plywood, which is glued on and stapled. The toggles in a Hollywood flat are placed on 2 ...
The exterior of the A.O. Smith Corporation Building in Milwaukee was clad entirely in aluminium by 1930, and 3-foot-square (0.91 m) siding panels of Duralumin sheet from Alcoa sheathed an experimental exhibit house for the Architectural League of New York in 1931. Most architectural applications of aluminium in the 1930s were on a monumental ...
In 1971 "Micro=Lam LVL" was introduced. "Micro=Lam LVL" consisted of laminated veneer lumber billets 4 feet (1.2 m) wide, 3 + 1 ⁄ 2 inches (89 mm) thick, and 80 feet (24 m) long. Troutner proved the structural capabilities of his Micro=Lam product by building a house in Hagerman, Idaho, using beams made of Micro=Lam.