When.com Web Search

  1. Ads

    related to: butt wire splice connector

Search results

  1. Results From The WOW.Com Content Network
  2. Electrical connector - Wikipedia

    en.wikipedia.org/wiki/Electrical_connector

    [6]: 56 (e.g. pin headers, screw terminals, board-to-board connectors) Splice or butt connectors (primarily insulation displacement connectors) that permanently join two lengths of wire or cable; In computing, electrical connectors are considered a physical interface and constitute part of the physical layer in the OSI model of networking.

  3. Western Union splice - Wikipedia

    en.wikipedia.org/wiki/Western_union_splice

    The 1915 textbook Practical Electric Wiring describes the construction of the Western Union splice; short tie and long tie. The short tie splice has it being formed after stripping the insulation from a pair of wires for several inches, each, crossing the wires left over right as shown in figure part A; then, a hooked cross (figure part B) is formed holding the crossing point of the two wires ...

  4. Crimp (joining) - Wikipedia

    en.wikipedia.org/wiki/Crimp_(joining)

    Crimped connectors fulfill numerous uses, including termination of wires to screw terminals, blade terminals, ring/spade terminals, wire splices, or various combinations of these. A tube-shaped connector with two crimps for splicing wires in-line is called a butt splice connector. Single-wire crimp terminals include:

  5. IDC (electrical connector) - Wikipedia

    en.wikipedia.org/wiki/IDC_(electrical_connector)

    Modern IDC technology developed after and was influenced by research on wire-wrap and crimp connector technology originally pioneered by Western Electric, Bell Telephone Labs, and others. [3] Although originally designed to connect only solid (single-stranded) conductors, IDC technology was eventually extended to multiple- stranded wire as well.

  6. Twist-on wire connector - Wikipedia

    en.wikipedia.org/wiki/Twist-on_wire_connector

    Twist-on wire connectors are a type of electrical connector used to fasten two or more low-voltage (or extra-low-voltage) electrical conductors. They are widely used in North America and several European countries in residential, commercial and industrial building power wiring, but have been banned in some other jurisdictions.

  7. Line splice - Wikipedia

    en.wikipedia.org/wiki/Line_splice

    The wires are wrapped two to three times around each other . The bare veins on a length of about 3 cm "strangle" or "twist". In some cases, the strangulation is soldered. To isolate the splice, an insulating sleeve made of paper or plastic is pushed over it. The splicing of copper wires is mainly used on paper insulated wires.