Search results
Results From The WOW.Com Content Network
AHCI gives software developers and hardware designers a standard method for detecting, configuring, and programming SATA/AHCI adapters. AHCI is separate from the SATA 3 Gbit/s standard, although it exposes SATA's advanced capabilities (such as hot swapping and native command queuing ) such that host systems can utilize them.
In BIOS mode the legacy/BIOS booting is under CSMCORE. In true UEFI mode the RST is controlled under SataDriver / RstVmdDriver in BIOS. The Intel RAID ROM is the firmware in the motherboard BIOS that is used to create the RAID array. Note: The RST drivers can be used for RAID and also on a single drive as it contains an AHCI driver.
When enabled via the AHCI controller, this allows the SATA host bus adapter to enter a low-power state during periods of inactivity, thus saving energy. The drawback to this is increased periodic latency as the drive must be re-activated and brought back on-line before it can be used, and this will often appear as a delay to the end-user.
The problem is you get a board that came set up for IDE mode or you set it to IDE mode to avoid the need to use a floppy or slipstream or to use an older linux distro or whatever. Then sometime later you come to add a hard drive or or optical drive and find that half your disk controller ports are unusable without switching to ahci mode.
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring.
DragonFly BSD has supported AHCI with NCQ since 2.3 in 2009. [ 4 ] [ 5 ] Linux kernels support AHCI natively since version 2.6.19, and FreeBSD fully supports AHCI since version 8.0. Windows Vista and Windows 7 also natively support AHCI, but their AHCI support (via the msahci service) must be manually enabled via registry editing if controller ...
The BIOS uses the boot devices set in Nonvolatile BIOS memory , or, in the earliest PCs, DIP switches. The BIOS checks each device in order to see if it is bootable by attempting to load the first sector (boot sector). If the sector cannot be read, the BIOS proceeds to the next device.
ICH - 82801AA. The first version of the ICH was released in June 1999 along with the Intel 810 northbridge.While its predecessor, the PIIX, was connected to the northbridge through an internal PCI bus with a bandwidth of 133 MB/s, the ICH used a proprietary interface (called by Intel Hub Interface) that linked it to the northbridge through an 8-bit wide, 266 MB/s bus.