Search results
Results From The WOW.Com Content Network
Armour piercing discarding sabot munitions were developed to increase penetrating performance of anti-tank projectiles by generating higher impact velocity.A larger projectile would require a completely new weapon system, but increasing velocity faced the limitation that steel armour-piercing (AP) projectiles shattered at velocities above about 850 m/s when uncapped.
The M829 is an American armor-piercing fin-stabilized discarding sabot kinetic energy penetrator tank round.Modeling was done at the Ballistic Research Laboratory at Aberdeen Proving Ground, [1] which was incorporated into the Army Research Laboratory in 1992.
Armour-piercing discarding sabot (APDS) was initially the main design of the kinetic energy (KE) penetrator. The logical progression was to make the shot longer and thinner to increase its sectional density, thus concentrating the kinetic energy in a smaller area. However, a long, thin rod is aerodynamically unstable; it tends to tumble in ...
A sabot (UK: / s æ ˈ b oʊ, ˈ s æ b oʊ /, US: / ˈ s eɪ b oʊ /) is a supportive device used in firearm/artillery ammunitions to fit/patch around a projectile, such as a bullet/slug or a flechette-like projectile (such as a kinetic energy penetrator), and keep it aligned in the center of the barrel when fired.
Armour-piercing fin-stabilized discarding sabot (APFSDS) using a sabot and tracer (APFSDS-T). Typically used against other modern tanks. There are different ways to measure penetration value. NATO uses the 50% criteria against 260BHN Steel, while the Soviet/Russia standard is higher (80% had to go through). [citation needed]
The round consists of a sub-calibre penetrator made of tungsten, enclosed in a discarding sabot.The sabot provides stability during the initial stages of flight and is discarded upon exiting the barrel, allowing the penetrator to continue towards the target with high velocity.
Sub-caliber armour-piercing discarding sabot projectile. Here seen with and without its sabot as well as its internal tungsten core. The most traditional way to fire sub-caliber ammunition is to fit the projectile with an expendable sabot. The sabot is a device which fills out the missing caliber when the projectile is fired and then leaves the ...
The SLAP design incorporates a polymer sabot, which allows for the use of a tungsten penetrator projectile of a lesser diameter than the original bore.By using the casing of a large cartridge with a lightweight projectile, the velocity of the projectile is greatly increased and the sectional density is improved without requiring a (potentially dangerous) increase in chamber pressure.