Ad
related to: sata mode ide or raid
Search results
Results From The WOW.Com Content Network
Many SATA controllers offer selectable modes of operation: legacy Parallel ATA emulation (more commonly called IDE Mode), standard AHCI mode (also known as Native Mode), or vendor-specific RAID (which generally enables AHCI in order to take advantage of its capabilities).
The SAS is a new generation serial communication protocol for devices designed to allow for much higher speed data transfers and is compatible with SATA. SAS uses a mechanically identical data and power connector to standard 3.5-inch SATA1/SATA2 HDDs, and many server-oriented SAS RAID controllers are also capable of addressing SATA hard drives.
As of February 2007 Intel started integrating their own Matrix RAID controller in their more upmarket motherboards, giving control over 4 devices and an additional 2 SATA connectors, and totalling 6 SATA connections (3 Gbit/s each). For backward compatibility one IDE connector able to connect 2 ATA devices (100 Mbit/s) is also present.
The first mode is the Intel driver SATA normal and the latter mode is a fake RAID. [1] Up to version 4 it is included on Intel Application Accelerator RAID Edition , [ 2 ] between versions 5 and 8.9 it is included on Intel Matrix Storage Manager ( IMSM ), since version 9 it is included on Intel Rapid Storage Technology ( IRST ) preferring the ...
Parallel ATA (PATA), originally AT Attachment, also known as Integrated Drive Electronics (IDE), is a standard interface designed for IBM PC-compatible computers.It was first developed by Western Digital and Compaq in 1986 for compatible hard drives and CD or DVD drives.
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
[1] [2] Because the ATA TCQ is rarely used, Parallel ATA (and the IDE mode of some chipsets) usually only support one outstanding command per port. For NCQ to be enabled, it must be supported and enabled in the SATA host bus adapter and in the hard drive itself.
In logical block addressing, only one number is used to address data, and each linear base address describes a single block. The LBA scheme replaces earlier schemes which exposed the physical details of the storage device to the software of the operating system. Chief among these was the cylinder-head-sector (CHS) scheme, where blocks were addressed by means