Ad
related to: toilet cistern will not flush drain tank video
Search results
Results From The WOW.Com Content Network
The flushing trough was developed by Adamsez Limited and a patent was issued to MJ Adams in 1912 for a flushing trough that used the bell siphon flushing system. [1] A further patent was issued in 1928 to AH Adams for a flushing trough that used the plate siphon mechanism, [2] marketed as the 'Epic'. Advertisements by Adamsez stated that 25,000 ...
A typical flush toilet is a fixed, vitreous ceramic bowl (also known as a pan) which is connected to a drain. After use, the bowl is emptied and cleaned by the rapid flow of water into the bowl. This flush may flow from a dedicated tank (cistern), a high-pressure water pipe controlled by a flush valve, or by manually pouring water into the bowl.
When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.
In most cases, they replace mains pressure with the pressure of that from a raised gravity cistern. Common examples of an air gap in domestic plumbing are: Taps above washbasins; Cold water cisterns, where the float valve outlet must be above the overflow water level. The previous practice of taking a "silencing tube" from the float valve to ...
A typical flush toilet is a ceramic bowl (pan) connected on the "up" side to a cistern (tank) that enables rapid filling with water, and on the "down" side to a drain pipe that removes the effluent. When a toilet is flushed, the sewage should flow into a septic tank or into a system connected to a sewage treatment plant .
A flushing trough is a type of cistern used to serve more than one WC pan at one time. These cisterns are becoming less common, however. The cistern was the genesis of the modern bidet. [citation needed] At the beginning of the flush cycle, as the water level in the toilet cistern tank drops, the flush valve flapper falls back to the bottom ...
A flush occurs while it is in its open mid positions. Because the water is gradually shut off, slower water at the end of the cycle that will not activate the siphon serves to refill the bowl. The valve cannot be kept open by holding the flush lever in the activated position, wasting water, because this only sends the main cylinder valve all ...
Squat toilet (flush toilet) with water cistern for flushing (Cape Town, South Africa) A squat toilet (or squatting toilet) is a toilet used by squatting, rather than sitting. This means that the posture for defecation and for female urination is to place one foot on each side of the toilet drain or hole and to squat over it.