Search results
Results From The WOW.Com Content Network
Premium High Speed HDMI Cable; Premium High Speed HDMI Cable with Ethernet; In conjunction with the HDMI 2.1 specification, a third category of cable was announced on January 4, 2017, called "48G". [81] Also known as Category 3 HDMI or "Ultra High Speed" HDMI, the cable is designed to support the 48 Gbit/s bandwidth of HDMI 2.1, supporting 4K ...
Download as PDF; Printable version; In other projects ... this page lists both the internal ribbon and external communications cable standards together in one ...
Coordinated Video Timings (CVT; VESA-2013-3 v1.2 [1]) is a standard by VESA which defines the timings of the component video signal.Initially intended for use by computer monitors and video cards, the standard made its way into consumer televisions.
The data is transmitted via the cable connecting the display and the graphics card; VGA, DVI, DisplayPort and HDMI are supported. [ citation needed ] The EDID is often stored in the monitor in the firmware chip called serial EEPROM (electrically erasable programmable read-only memory) and is accessible via the I²C-bus at address 0x50 .
An attempt by Apple to deal with cable clutter, by combining five separate cables from computer to monitor. Female port (20-pin) Digital Flat Panel (DFP) Used with the PanelLink digital video protocol. Deprecated. Made obsolete by DVI. 3D model of a UDI connector Unified Display Interface: Proposed to replace both DVI and HDMI.
Schematic of a TMDS link used as a link for digital component video data (RGB) between a video controller (PC) and a display controller (Monitor) in interfaces such as DVI or HDMI Transition-minimized differential signaling ( TMDS ) is a technology for transmitting high-speed serial data used by the DVI [ 1 ] and HDMI video interfaces, as well ...
Display Data Channel (DDC) is a collection of protocols for digital communication between a computer display and a graphics adapter that enable the display to communicate its supported display modes to the adapter and that enable the computer host to adjust monitor parameters, such as brightness and contrast.
OC-48 is also used as a transmission speed for tributaries from OC-192 nodes in order to optimize card slot utilization where lower speed deployments are used. Slower cards that drop to OC-12, OC-3 or STS-1 speeds are more commonly found on OC-48 terminals, where use of these cards on an OC-192 terminal would not allow for full use of the ...