Ad
related to: class 1 load manager p/n 101709 4 10 40 fertilizer
Search results
Results From The WOW.Com Content Network
It uses a specially fluidized and siliconized monoammonium phosphate powder. [1] ABC dry chemical is usually a mix of monoammonium phosphate and ammonium sulfate, the former being the active component. The mix between the two agents is usually 40–60%, 60–40%, or 90–10% depending on local standards worldwide.
Fertilizers with additional macronutrients (S, Ca, Mg) may add more numbers to the N-P-K ratio to indicate the amount. The additional numbers are similarly reported in the oxide mass fraction form. For example, a Polish fertilizer labeled "NPK (Ca,S) 4-12-12 (14-29)" has an equivalent of 14% soluble calcium oxide and 29% total sulfur trioxide. [6]
The classification system was first developed by Hogentogler and Terzaghi in 1929, [1] but has been revised several times since. AASHTO Soil Classification System (from AASHTO M 145 or ASTM D3282) General Classification
The cell output is rated in millivolts per volt (mV/V) of the difference voltage at full rated mechanical load. So a 2.96 mV/V load cell will provide 29.6 millivolt signal at full load when excited with 10 volts. Typical sensitivity values are 1 to 3 mV/V. Typical maximum excitation voltage is around 15 volts.
The load index on a passenger-car tire is a two- or three-digit numerical code used to cross-reference a load & inflation table that will give the maximum load each tire can carry at a given pressure. The load index is sometimes used in conjunction with the load range, which appears elsewhere on the tire.