Ads
related to: cinch steel deck railing hardware
Search results
Results From The WOW.Com Content Network
The typical deck railing is generally built from pressure treated lumber. [14] Posts on a deck are also typically pressure treated wood and standard sizes are 4x4, 6x6, and 8x8. These posts give structural support to the railing assembly and are the most critical part for the safety of the guard rail assembly. [15]
Cable and strand is available in galvanized carbon steel, type 304 stainless steel, or the highly corrosion resistant, type 316 stainless steel (best for coastal areas). The most common cable construction is 1x19 type construction strand, which is 19 cables twisted in a single bundle, whereas for example, 7x7 would be 7 cable bundles of 7 ...
The terms rail anchors, tie plates, chairs and track fasteners are used to refer to parts or all of a rail fastening system. The components of a rail fastening system may also be known collectively as other track material, or OTM for short. Various types of fastening have been used over the years.
A fishplate, splice bar or joint bar is a metal or composites connecting plate used to bolt the ends of two rails into a continuous track. The name is derived from fish , [ 1 ] a wooden reinforcement of a "built-up" ship's mast that helped round out its desired profile. [ 2 ]
An example of a common residential guard rail (US) handrail (Brit.) is a wood railing around a deck or patio. In the US this is typically built on-site from pressure treated lumber thus featuring a simplistic design of vertical baluster spaced every 3.5 inches (8.9 cm) demonstrating compliance with Building Codes (Standards).
The width of devices that are mounted on a 35 mm "top hat" DIN rail generally use "modules" as a width unit, one module being 18 mm wide. For example, a small device (e.g. a circuit breaker) may have a width of 1 module (18 mm wide), while a larger device may have a width of 4 modules (4 × 18 mm = 72 mm).