Search results
Results From The WOW.Com Content Network
A VLAN access control list (VACL) provides access control for all packets that are bridged within a VLAN or that are routed into or out of a VLAN. Unlike regular Cisco IOS access control lists that are configured on router interfaces and applied on routed packets only, VACLs apply to all packets.
A Private VLAN divides a VLAN (Primary) into sub-VLANs (Secondary) while keeping existing IP subnet and layer 3 configuration. A regular VLAN is a single broadcast domain, while private VLAN partitions one broadcast domain into multiple smaller broadcast subdomains. Primary VLAN: Simply the original VLAN. This type of VLAN is used to forward ...
A VLAN can also serve to restrict access to network resources without regard to physical topology of the network. [a] VLANs operate at the data link layer of the OSI model. Administrators often configure a VLAN to map directly to an IP network, or subnet, which gives the appearance of involving the network layer.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
pfSense is a firewall/router computer software distribution based on FreeBSD. The open source pfSense Community Edition (CE) and pfSense Plus is installed on a physical computer or a virtual machine to make a dedicated firewall/router for a network. [ 3 ]
A wildcard mask can be thought of as an inverted subnet mask. For example, a subnet mask of 255.255.255.0 (11111111.11111111.11111111.00000000 2) inverts to a wildcard mask of 0.0.0.255 (00000000.00000000.00000000.11111111 2). A wild card mask is a matching rule. [2] The rule for a wildcard mask is: 0 means that the equivalent bit must match
In Internet networking, a private network is a computer network that uses a private address space of IP addresses.These addresses are commonly used for local area networks (LANs) in residential, office, and enterprise environments.
An example of how to configure a simple, three switch MSTP topology wherein a layer-two access switch carries four VLANs and has two uplinks to two distribution switches, can be found here: MSTP Configuration Guide A good configuration view, from the above-mentioned example shall be: S3# show spanning-tree mst