Search results
Results From The WOW.Com Content Network
A VLAN access control list (VACL) provides access control for all packets that are bridged within a VLAN or that are routed into or out of a VLAN. Unlike regular Cisco IOS access control lists that are configured on router interfaces and applied on routed packets only, VACLs apply to all packets.
A Private VLAN divides a VLAN (Primary) into sub-VLANs (Secondary) while keeping existing IP subnet and layer 3 configuration. A regular VLAN is a single broadcast domain, while private VLAN partitions one broadcast domain into multiple smaller broadcast subdomains. Primary VLAN: Simply the original VLAN. This type of VLAN is used to forward ...
A VLAN can also serve to restrict access to network resources without regard to physical topology of the network. [a] VLANs operate at the data link layer of the OSI model. Administrators often configure a VLAN to map directly to an IP network, or subnet, which gives the appearance of involving the network layer.
The open source pfSense Community Edition (CE) and pfSense Plus is installed on a physical computer or a virtual machine to make a dedicated firewall/router for a network. [3] It can be configured and upgraded through a web-based interface, and requires no knowledge of the underlying FreeBSD system to manage. [4] [5]
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
An example of how to configure a simple, three switch MSTP topology wherein a layer-two access switch carries four VLANs and has two uplinks to two distribution switches, can be found here: MSTP Configuration Guide A good configuration view, from the above-mentioned example shall be: S3# show spanning-tree mst
Port forwarding via NAT router. In computer networking, port forwarding or port mapping is an application of network address translation (NAT) that redirects a communication request from one address and port number combination to another while the packets are traversing a network gateway, such as a router or firewall.
This allows an attacker's fake VLAN tag to be read by the next switch. [4] Double tagging can be mitigated by any of the following actions (incl. IOS example): Simply do not put any hosts on VLAN 1 (the default VLAN). i.e., assign an access VLAN other than VLAN 1 to every access port Switch (config-if)# switchport access vlan 2