Search results
Results From The WOW.Com Content Network
For example, UI is used to measure timing jitter in serial communications or in on-chip clock distributions. This measurement unit is extensively used in jitter literature. Examples can be found in various ITU-T Recommendations, [1] or in the tutorial from Ransom Stephens. [2]
Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies deviation lower frequencies below 10 Hz as wander and higher frequencies at or above 10 Hz as jitter. [2]
Each time the peak-to-peak distance between the largest and smallest TIE in that window is noted. This distance varies as the window moves, being maximal for some window position. This maximal distance is known as MTIE for the given observation interval.
This of course means that the clock skew between two points varies from cycle to cycle, which is a complexity that is rarely mentioned. Many other authors use the term clock skew only for the spatial variation of clock times, and use the term clock jitter to represent the rest of the total clock timing uncertainty. This of course means that the ...
One example for an IEEE 802.1Qbv scheduler configuration is visible in figure 1: figure 1: Example IEEE 802.1Qbv schedule. In this example, each cycle consists of two time slices. Time slice 1 only allows the transmission of traffic tagged with VLAN priority 3, and time slice 2 in each cycle allows for the rest of the priorities to be sent.
The system time clock (STC) decoder, when properly implemented, provides a highly accurate time base that is used to synchronize audio and video elementary streams. Timing in MPEG-2 references this clock. For example, the presentation time stamp (PTS) is intended to be relative to the PCR. The first 33 bits are based on a 90 kHz clock.
Clock synchronization is a topic in computer science and engineering that aims to coordinate otherwise independent clocks. Even when initially set accurately, real clocks will differ after some amount of time due to clock drift, caused by clocks counting time at slightly different rates. There are several problems that occur as a result of ...
Base stations need to know what time it is, and they usually get this knowledge from the outside world somehow (from a GPS Time and Frequency receiver, or from a synchronization source somewhere in the network they are connected to). But if the connection to the reference is lost then the base station will be on its own to establish what time ...