Ads
related to: wire yagi 40 meters 1 mile length 4pasternack.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
A single ground wire can provide antenna gain in the 3–6 dB range. This is a reflector element used to form a 2-element Yagi beam antenna. The wire length for the reflector element is 5% longer than the dipole-driven element positioned above it. The dipole is located at a distance of 0.15 wavelengths above the reflector element.
A Yagi–Uda antenna, or simply Yagi antenna, is a directional antenna consisting of two or more parallel resonant antenna elements in an end-fire array; [1] these elements are most often metal rods (or discs) acting as half-wave dipoles. [2]
A Yagi antenna may have a reflector on one side of the driven element, and one or more directors on the other side. If all the elements are in a plane, usually only one reflector is used, because additional ones give little improvement in gain, but sometimes additional reflectors are mounted above and below the plane of the antenna on a ...
Moxon antenna for the 20-meter band.The antenna is the faint rectangle of wires held in tension by the bent X-shaped support frame. Moxon antenna for the 2-meter band. The Moxon antenna or Moxon rectangle is a simple and mechanically rugged two-element parasitic array, single-frequency antenna. [1]
On October 10, the Third National Radio Conference made three shortwave bands available to U.S. amateurs [8] at 80 meters (3.75 MHz), 40 meters (7 MHz) and 20 meters (14 MHz). These were allocated worldwide, while the 10-meter band (28 MHz) was created by the Washington International Radiotelegraph Conference [ 9 ] on 25 November 1927.
The antenna rod and its image together act like a dipole antenna of twice the length, so a monopole over an infinite, perfectly conducting plane has a radiation pattern identical to the top half of the pattern of a vertical dipole of twice the length. [1] [70] [71] For the quarter wave monopole, the antenna acts like a half wave dipole.
[4] The Yagi and the LPDA designs look very similar at first glance, as they both consist of a number of dipole elements mounted along a support boom. The Yagi, however, has only a single driven element connected to the transmission line, usually the second one from the back of the array, the remaining elements are parasitic. The Yagi antenna ...
Assuming the building is about 20 feet tall, the length of wire seems to be on the order of 100 feet long – too short to be an HF Beverage antenna. Random wire antenna Moxon (1993) describes the random-wire antenna as an "odd bit of wire". [15] [page needed] It is the typical informal antenna erected for receiving shortwave and AM radio.