Search results
Results From The WOW.Com Content Network
While uRPF is used as an ingress filtering mechanism, it is affected by reverse-path forwarding. Reverse path filters are typically used to disable asymmetric routing where an IP application has a different incoming and outgoing routing path. Its intent is to prevent a packet entering one interface from leaving via the other interfaces. Reverse ...
Topology broadcast based on reverse-path forwarding (TBRPF) is a link-state routing protocol for wireless mesh networks. The obvious design for a wireless link-state protocol (such as the optimized link-state routing protocol) transmits large amounts of routing data, and this limits the utility of a link-state protocol when the network is made of moving nodes.
To implement the multicast routing, Internet Group Management Protocol (IGMP) and a multicast routing protocol (Reverse-path forwarding, PIM-SM) for registration subscriber grouping and control traffic are required for multicast transmission. [2] [3] [4] Regarding IP multicast, it is a technique for one-to-many communication over an IP network ...
Topology Broadcast based on Reverse-Path Forwarding routing protocol (TBRPF; RFC 3684) 749: Yes: Kerberos administration [11] 750: Yes: kerberos-iv, Kerberos version IV 751: Unofficial: kerberos_master, Kerberos authentication 752: Unofficial: passwd_server, Kerberos password (kpasswd) server 753 Yes: Reverse Routing Header (RRH) [111] Unofficial
PIM is not dependent on a specific unicast routing protocol; it can make use of any unicast routing protocol in use on the network. PIM does not build its own routing tables. PIM uses the unicast routing table for reverse-path forwarding. [1]: 56–57 There are four variants of PIM:
Forwarding to another address has always worked by rewriting the address in the forward path also known as RCPT TO, if and only if the forwarding MTA accepted the responsibility for both forwarding the mail and returning potential bounce messages to the sender. RFC 821 and all later SMTP specifications offer two result codes for this situation:
Controlled flooding has its own two algorithms to make it reliable, SNCF (Sequence Number Controlled Flooding) and RPF (reverse-path forwarding). In SNCF, the node attaches its own address and sequence number to the packet, since every node has a memory of addresses and sequence numbers.
Raster Product Format, a GIS file format Reverse-path forwarding , a technique in multicast routing in networking Reverse power feeding , in broadband networking