Search results
Results From The WOW.Com Content Network
The sensible heat of a thermodynamic process may be calculated as the product of the body's mass (m) with its specific heat capacity (c) and the change in temperature (): =. Joule described sensible heat as the energy measured by a thermometer. Sensible heat and latent heat are not special forms of energy. Rather, they describe exchanges of ...
The terms sensible heat and latent heat refer to energy transferred between a body and its surroundings, defined by the occurrence or non-occurrence of temperature change; they depend on the properties of the body. Sensible heat is sensed or felt in a process as a change in the body's temperature.
Heat transfer can either occur as sensible heat (differences in temperature without evapotranspiration) or latent heat (the energy required during a change of state, without a change in temperature). The Bowen ratio is generally used to calculate heat lost (or gained) in a substance; it is the ratio of energy fluxes from one state to another by ...
The Stefan condition: () = ((),) where is the Stefan number, the ratio of latent to specific sensible heat (where specific indicates it is divided by the mass). Note this definition follows naturally from the nondimensionalisation and is used in many texts [ 8 ] [ 9 ] however it may also be defined as the inverse of this .
Heat flux can be directly measured using a single heat flux sensor located on either surface or embedded within the material. Using this method, knowing the values of k and x of the material are not required. The multi-dimensional case is similar, the heat flux goes "down" and hence the temperature gradient has the negative sign:
Heat fluxes across the stable vapor layers are low but rise slowly with temperature. Any contact between the fluid and the surface that may be seen probably leads to the extremely rapid nucleation of a fresh vapor layer ("spontaneous nucleation"). At higher temperatures still, a maximum in the heat flux is reached (the critical heat flux, or CHF).
Generally the net longwave radiation term is negative, meaning a net loss of energy from the snowpack. Latent temperature flux is the energy removed from or delivered to the snowpack which accompanies the mass transfers of evaporation, sublimation, or condensation. Sensible heat flux is the heat flux due to convection between the air and snowpack.
C p is therefore the slope of a plot of temperature vs. isobaric heat content (or the derivative of a temperature/heat content equation). The SI units for heat capacity are J/(mol·K). Molar heat content of four substances in their designated states above 298.15 K and at 1 atm pressure. CaO(c) and Rh(c) are in their normal standard state of ...