Ads
related to: high gain antenna with sma
Search results
Results From The WOW.Com Content Network
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
A high-gain antenna (HGA) is a directional antenna with a focused, narrow beam width, permitting more precise targeting of the radio signals. [1] Most commonly referred to during space missions , [ 2 ] these antennas are also in use all over Earth , most successfully in flat, open areas where there are no mountains to disrupt radiowaves.
When considering an antenna's directional pattern, gain with respect to a dipole does not imply a comparison of that antenna's gain in each direction to a dipole's gain in that direction. Rather, it is a comparison between the antenna's gain in each direction to the peak gain of the dipole (1.64). In any direction, therefore, such numbers are 2 ...
A directive antenna with moderate gain of about 8 dBi often used at UHF frequencies. Consists of a dipole mounted in front of two reflective metal screens joined at an angle, usually 90°. Used as a rooftop UHF television antenna and for point-to-point data links. Parabolic The most widely used high gain antenna at microwave frequencies and above.
Corrugated horn antenna with a bandwidth of 3.7 to 6 GHz designed to attach to SMA waveguide feedline. This was used as a feedhorn for a parabolic antenna on a British military base. Exponential feed horn for 26-meter (85 ft) Cassegrain spacecraft communication antenna at NASA's Goldstone Deep Space Communications Complex.
Vivaldi antennas are useful for any frequency, as all antennas are scalable in size for use at any wavelength. Printed circuit technology makes this type antenna cost effective for microwave frequencies 1 GHz or higher. An inexpensive Vivaldi antenna is etched upon a printed circuit board and fed with a soldered-on coaxial cable and SMA connector.