Ad
related to: esp32 which pins to use on car parts catalog in 60 s ford convertible sports car
Search results
Results From The WOW.Com Content Network
Serial communication on pin D0 (RX) and pin D1 (TX). used to receive (RX) and transmit (TX) TTL serial data. These pins are connected to the corresponding pins of the FTDI USB-to-TTL serial chip. By sliding the switch (S1), RX/TX pins can be re-routed to Bluetooth UART connector. Linduino One ATmega328 Linear Technology Corporation [70]
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
This is a list of auto parts, which are manufactured components of automobiles. This list reflects both fossil-fueled cars (using internal combustion engines) and electric vehicles; the list is not exhaustive. Many of these parts are also used on other motor vehicles such as trucks and buses.
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
There were even a series of special EEC-IV modules designed for use in Formula 1 race cars, making Ford one of the earliest adopters of digital electronics on a race car. These EEC-IV were used on the Ford/Cosworth 1.5L turbo Formula 1 engine in 1985. [4] This engine with the EEC-IV was used by Haas/FORCE F1 a.k.a. Hass/Lola.
General Motors implemented both a 5-pin connector and a 12-pin connector, with the 12 pin connector (Packard/Delco/Delphi part number 12020043) being used in the vast majority of GM cars. Lotus implemented a 10-pin connector. The pins are given letter designations in the following layouts (as seen from the front of the vehicle connector):
The Type 2 connector is equipped with seven pin connectors, which are used for communication between the vehicle and charger using the J1772 signaling protocol, and for either single or 3-phase AC power with a maximum voltage of 500 V, thereby delivering up to 43kW of power.
The steering kingpin is held in place by the forked ends of a beam axle on a Ford Model T. The kingpin (also king-pin, king pin and k pin) [1] [2] is the main pivot in the steering mechanism of a car or other vehicle. The term is also used to refer to part of a fifth wheel coupling apparatus for a semi and its trailer or other load.