Ad
related to: can you use tyvek inside a house frame with wood ceiling and walls
Search results
Results From The WOW.Com Content Network
The completed frame of a modern timber-frame house Ridge-post framing (left) and story framing (right, with jetties) Historically, the timbers would have been hewn square using a felling axe and then surface-finished with a broadaxe. If required, smaller timbers were ripsawn from the hewn baulks using pitsaws or frame saws.
Housewrap (or house wrap), also known by the genericized trademark homewrap (or home wrap), generally denotes a modern synthetic material used to protect buildings. Housewrap functions as a weather-resistant barrier , preventing rain or other forms of moisture from getting into the wall assembly while allowing water vapor to pass to the exterior.
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
Air barriers control air leakage into and out of the building envelope.Air barrier products may take several forms: Mechanically-attached membranes, also known as housewraps, usually a polyethylene-fiber or spun-bonded polyolefin, such as Tyvek is a generally accepted moisture barrier and an air barrier (ASTM E2178).
Box houses (boxed house, box frame, [16] box and strip, [17] piano box, single-wall, board and batten, and many other names) have minimal framing in the corners and widely spaced in the exterior walls, but like the vertical plank wall houses, the vertical boards are structural. [18]
Whether you’re looking for wood-clad walls, a wooden bathtub, or just some wood cabinets, here are 12 ways to bring the look of wood into your bathroom now.
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
In construction, a dwang (Scotland and New Zealand), [1] [2] [3] nogging piece, nogging, noggin or nog (England and Australia; all derived from brick nog), [4] [5] or blocking (North America), is a horizontal bracing piece used between wall studs to give rigidity to the wall frames of a building. Noggings may be made of timber, steel, or aluminium.