Ad
related to: rf transmitter block diagram labeled model of the cell system with two body
Search results
Results From The WOW.Com Content Network
A radio transmitter or just transmitter is an electronic device which produces radio waves with an antenna. Radio waves are electromagnetic waves with frequencies between about 30 Hz and 300 GHz. The transmitter itself generates a radio frequency alternating current, which is applied to the antenna. When excited by this alternating current, the ...
Block diagram of a superheterodyne receiver. The RF front end consists of the components on the left colored red. In a radio receiver circuit, the RF front end, short for radio frequency front end, is a generic term for all the circuitry between a receiver's antenna input up to and including the mixer stage. [1]
It consisted of one or more tuned RF amplifiers, each consisting of a tuned circuit which functioned as a bandpass filter followed by an amplifier; a detector (demodulator) to extract the audio waveform from the radio carrier wave; followed by an audio amplifier.
RF module (with a ruler for size reference) An RF module (short for radio-frequency module) is a (usually) small electronic device used to transmit and/or receive radio signals between two devices. In an embedded system it is often desirable to communicate with another device wirelessly.
The top-to-top half-wave connecting wire serves as a phasing line that keeps radiation from the two antennas in-phase; even if the system feedpoint is connected elsewhere. Since a quarter-wave monopole's current is highest nearest its feedpoint, the nominal top-feed puts the maximum radiating current up high, at the top of each monopole.
Above: Direct modulation, below superheterodyne transmitter. There are two types of transmitters. In some transmitters, the baseband information signal (audio (AF), video (VF) etc.) modulates the radio frequency (RF) signal. These direct modulation transmitters are relatively simple.
Cellular lattice tower A cell tower in Peristeri, Greece. A cell site, cell phone tower, cell base tower, or cellular base station is a cellular-enabled mobile device site where antennas and electronic communications equipment are placed (typically on a radio mast, tower, or other raised structure) to create a cell, or adjacent cells, in a cellular network.
Radio-frequency (RF) engineering is a subset of electrical engineering involving the application of transmission line, waveguide, antenna, radar, and electromagnetic field principles to the design and application of devices that produce or use signals within the radio band, the frequency range of about 20 kHz up to 300 GHz.