When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Pore pressure gradient - Wikipedia

    en.wikipedia.org/wiki/Pore_pressure_gradient

    Saltwater is 0.444 psi/ft (2.5% higher than fresh water but this not general and depends on salt concentration in water) Pore pressure in the rock could be as high as 1.0 psi/ft of depth (19.25 lb/gal) A well with 5,000 feet of seawater and 15,000 feet of rock could have an overburden pressures at the bottom as high as 17,220 psi (5000 * 0.444 ...

  3. Comparison of the imperial and US customary measurement systems

    en.wikipedia.org/wiki/Comparison_of_the_imperial...

    Volume may be measured either in terms of units of cubic length or with specific volume units. The units of cubic length (the cubic inch, cubic foot, cubic mile, etc.) are the same in the imperial and US customary systems, but they differ in their specific units of volume (the bushel, gallon, fluid ounce, etc.).

  4. Orders of magnitude (pressure) - Wikipedia

    en.wikipedia.org/wiki/Orders_of_magnitude_(pressure)

    120–290 psi Pressure used in boilers of steam locomotives [citation needed] 1.1 MPa 162 psi Pressure of an average human bite [citation needed] 2.8–8.3 MPa 400–1,200 psi Pressure of carbon dioxide propellant in a paintball gun [64] 5 MPa 700 psi Water pressure of the output of a coin-operated car wash spray nozzle [58] 5 MPa 700 psi

  5. English Engineering Units - Wikipedia

    en.wikipedia.org/wiki/English_Engineering_Units

    Units for other physical quantities are derived from this set as needed. In English Engineering Units, the pound-mass and the pound-force are distinct base units, and Newton's Second Law of Motion takes the form = where is the acceleration in ft/s 2 and g c = 32.174 lb·ft/(lbf·s 2).

  6. Standard cubic feet per minute - Wikipedia

    en.wikipedia.org/wiki/Standard_cubic_feet_per_minute

    Actual cubic foot per minute (ACFM) is the volume of gas flowing anywhere in a system, taking into account its temperature and pressure. If the system were moving a gas at exactly the "standard" condition, then ACFM would equal SCFM. This usually is not the case as the most important change between these two definitions is the pressure.

  7. Standard cubic foot - Wikipedia

    en.wikipedia.org/wiki/Standard_cubic_foot

    The pressure definition differs between sources, but are all close to normal sea level air pressure. A pressure of 14.696 pounds per square inch (1.00000 atm; 101.325 kPa). [2] This is the same pressure as the SI system standard pressure. Gives 1.1953 moles per scf. A pressure of 101.35 kilopascals (1.0002 atm; 14.700 psi). [2]

  8. Pressure system - Wikipedia

    en.wikipedia.org/wiki/Pressure_system

    A pressure system is a peak or lull in the sea level pressure distribution, a feature of synoptic-scale weather. The surface pressure at sea level varies minimally, with the lowest value measured 87 kilopascals (26 inHg) and the highest recorded 108.57 kilopascals (32.06 inHg).

  9. Foot-pound (energy) - Wikipedia

    en.wikipedia.org/wiki/Foot-pound_(energy)

    The foot-pound force (symbol: ft⋅lbf, [1] ftlb f, [2] or ftlb [3]) is a unit of work or energy in the engineering and gravitational systems in United States customary and imperial units of measure. It is the energy transferred upon applying a force of one pound-force (lbf) through a linear displacement of one foot.