Ads
related to: 10k dexter axle parts near me
Search results
Results From The WOW.Com Content Network
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
Northway Motor Plant/General Motors Truck Co. Plant No. 7/Chevrolet Gear and Axle Div. Detroit, Michigan: United States: Northway engines, Axles, parts for past model Chevrolets: 1920: 1994: Located at 1806 Holbrook Ave. Northway Motor and Manufacturing Company was acquired by GM in 1909, becoming Northway Motor and Manufacturing Division.
It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing. Dana 80's are made as full floating, rear axles only and are a step up in overall strength compared to the Dana 70. 1988 Ford was the first company to use the Dana 80.
Dana differential case #706400 [3] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.
The CCW-353 (C for 1941 design, C for conventional cab, and W for tandem rear axles) was a near identical version of the CCKW-353, that lacked its front-wheel drive, resulting in an officially purely on-road, and therefore 5-ton rated, 6×4 version of the same truck. A beam front axle was used, with the transfer case locked in high range.
The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep