Ads
related to: tape drive for home use software
Search results
Results From The WOW.Com Content Network
DDS tape drive (bottom). Above, from left to right: DDS-4 tape (20 GB), 112m Data8 tape (2.5 GB), QIC DC-6250 tape (250 MB), and a 3.5" floppy disk (1.44 MB). A tape drive is a data storage device that reads and writes data on a magnetic tape. Magnetic-tape data storage is typically used for offline, archival data storage. Tape media generally ...
A virtual tape library (VTL) is a data storage virtualization technology used typically for backup and recovery purposes. A VTL presents a storage component (usually hard disk storage) as tape libraries or tape drives for use with existing backup software.
Modern tape drives offer a speed matching feature, where the drive can dynamically decrease the physical tape speed as needed to avoid shoe-shining. [ 23 ] In the past, the size of the inter-block gap was constant, while the size of the data block was based on host block size, affecting tape capacity – for example, on count key data storage.
The Linear Tape File System (LTFS) is a file system that allows files stored on magnetic tape to be accessed in a similar fashion to those on disk or removable flash drives. It requires both a specific format of data on the tape media and software to provide a file system interface to the data.
TS7740 and TS7720 are designed to speed up tape backups and restores by using a tiered hierarchy of disk and tape to make more efficient use of tape drives. [ 44 ] IBM System Storage TS7650G ProtecTIER Deduplication Gateway – Designed to meet the disk-based data protection needs of the enterprise data center while reducing costs.
The Ditto drive series was a proprietary magnetic tape data storage system released by Iomega during the 1990s. It was marketed as a backup device for personal computers . They were released in several capacities ranging from the original Ditto 250 drive (250MB compressed capacity per cartridge) to the DittoMAX drive, a compatible format with ...
In addition to the standard packet format, the driver gives the user direct control over the tape drive motors and reading and writing the tones. This is used with audio tapes to control playback. A typical scenario has an audio recording on the "left" track and short bursts of 5327 Hz at key locations within the audio.
Each tape is a continuous loop, unlike cassette tape. It was intended to compete with Sinclair's ZX Interface 1 and ZX Microdrive. The Wafadrive comprises two continuous loop stringy floppy tape drives, an RS-232 interface and Centronics parallel port. The drives can run at two speeds: High speed (for seeking) and low speed (for reading/writing ...