Ads
related to: piston connecting rod design for boat engine for sale
Search results
Results From The WOW.Com Content Network
A connecting rod, also called a 'con rod', [1] [2] [3] is the part of a piston engine which connects the piston to the crankshaft. Together with the crank, the connecting rod converts the reciprocating motion of the piston into the rotation of the crankshaft. [4] The connecting rod is required to transmit the compressive and tensile forces from ...
A return connecting rod, [1] [2] return piston rod [i] or (in marine parlance) double piston rod engine [2] or back-acting engine is a particular layout for a steam engine. The key attribute of this layout is that the piston rod emerges from the cylinder to the crosshead , but the connecting rod then reverses direction and goes backwards to the ...
In internal combustion engines, the gudgeon pin (English, wrist pin or piston pin US English) connects the piston to the connecting rod, and provides a bearing for the connecting rod to pivot upon as the piston moves. [1] In very early engine designs, including those driven by steam, and many very large stationary or marine engines, the gudgeon ...
The engine has crosshead bearings so the always-vertical piston rods create a tight seal under the pistons. Consequently, the lubrication of the engine is split: the cylinders and the crankcase use different lubricants, each being specialised for its designated role. The cylinders are lubricated by continuous timed injection of consumable ...
The Deltic-powered Hunt-class mine countermeasures vessel HMS Ledbury. Development began in 1947 and the first Deltic model was the D18-11B, produced in 1950. It was designed to produce 2,500 hp (1,900 kW) at 2000 rpm for a 15-minute rating; the continuous rating being 1,875 hp (1,398 kW) at 1700 rpm, based on a 10,000-hour overhaul or replacement life. [3]
Crankshaft, pistons and connecting rods for a typical internal combustion engine Marine engine crankshafts from 1942. The crankshaft is located within the engine block and held in place via main bearings which allow the crankshaft to rotate within the block. [3] The up-down motion of each piston is transferred to the crankshaft via connecting ...
A trunk engine locates the connecting rod within a large-diameter hollow piston. This "trunk" carries almost no load. The interior of the trunk is open to outside air, and is wide enough to accommodate the side-to-side motion of the connecting rod, which links a gudgeon pin at the piston head to an outside crankshaft.
Attached to the end of the crank by a pivot is a rod, usually called a connecting rod (conrod). The term often refers to a human-powered crank which is used to manually turn an axle, as in a bicycle crankset or a brace and bit drill. In this case a person's arm or leg serves as the connecting rod, applying reciprocating force to the crank.