Search results
Results From The WOW.Com Content Network
A potentiometric surface is the imaginary plane where a given reservoir of fluid will "equalize out to" if allowed to flow. A potentiometric surface is based on hydraulic principles. For example, two connected storage tanks with one full and one empty will gradually fill/drain to the same level. This is because of atmospheric pressure and gravity.
Here the 'IEEE 754 double value' resulting of the 15 bit figure is 3.330560653658221E-15, which is rounded by Excel for the 'user interface' to 15 digits 3.33056065365822E-15, and then displayed with 30 decimals digits gets one 'fake zero' added, thus the 'binary' and 'decimal' values in the sample are identical only in display, the values ...
Thus the potentiometric titration involve measurement of E cell with the addition of titrant. Types of potentiometric titration include acid–base titration (total alkalinity and total acidity), redox titration (HI/HY and cerate), precipitation titration (halides), and complexometric titration (free EDTA and Antical #5).
For general purposes, buffers at pH 4.00 and pH 10.00 are suitable. The pH meter has one calibration control to set the meter reading equal to the value of the first standard buffer and a second control to adjust the meter reading to the value of the second buffer. A third control allows the temperature to be set.
When a percentage is referenced with a non-linear taper, it relates to the resistance value at the midpoint of the shaft rotation. A 10% log taper would therefore measure 10% of the total resistance at the midpoint of the rotation; i.e. 10% log taper on a 10 kOhm potentiometer would yield 1 kOhm at the midpoint.
Figure 2 gives an example; in this example, the two x-intercepts differ by about 0.2 mL but this is a small discrepancy, given the large equivalence volume (0.5% error). Similar equations can be written for the titration of a weak base by strong acid (Gran, 1952; Harris, 1998).
Typically this equation is used to find the average T and S values near a pumping well, from drawdown data collected during an aquifer test. This is a simple form of inverse modeling, since the result ( s ) is measured in the well, r , t , and Q are observed, and values of T and S which best reproduce the measured data are put into the equation ...
Potentiometric solid state gas sensors have been generally classified into three broad groups. Type I sensors have an electrolyte containing mobile ions of the chemical species in the gas phase that it is monitoring. The commercial product, YSZ oxygen sensor, [1] is an example of type I.