Search results
Results From The WOW.Com Content Network
The shell method goes as follows: Consider a volume in three dimensions obtained by rotating a cross-section in the xy-plane around the y-axis. Suppose the cross-section is defined by the graph of the positive function f(x) on the interval [a, b]. Then the formula for the volume will be:
BGL – below ground level (used as a datum for depths in a well) BGS – British Geological Survey; BGT – borehole geometry tool; BGWP – base of ground-water protection; BH – bloodhound; BHA – bottom hole assembly (toolstring on coiled tubing or drill pipe) BHC – BHC gamma ray log [clarification needed] BHCA – BHC acoustic log ...
Many thousands of old underground tanks were replaced with newer tanks made of corrosion resistant materials (such as fiberglass, steel clad with a thick FRP shell, and well-coated steel with galvanic anodes) and others constructed as double walled tanks to form an interstice between two tank walls (a tank within a tank) which allowed for the ...
The first hole is dug on one side of the obstacle. This hole must be large enough to fit the tool and allow the operator to aim it. The hole also must be deep enough so that, as the tool compacts the ground, the surface remains undisturbed. The depth of the starting bore pit depends on the type of soil being worked in and how well it compacts.
Tunnel Construction. Tunnels are dug in types of materials varying from soft clay to hard rock. The method of tunnel construction depends on such factors as the ground conditions, the ground water conditions, the length and diameter of the tunnel drive, the depth of the tunnel, the logistics of supporting the tunnel excavation, the final use and shape of the tunnel and appropriate risk management.
The initial design called for an autonomous device equipped with a drill head that would be rotated by expanding gases generated by a propellant burning inside a combustion chamber, in a manner similar to a Segner wheel. As the hot gases escaped the slits in the drill head at high speeds, they would break down the ground in front of the device.
The method uses pneumatic percussive blows to drive the pipe through the ground. The leading edge of the pipe is almost always open, and is typically closed only when smaller pipes are being installed. The shape allows a small overcut (to reduce friction between the pipe and soil and improve load conditions on the pipe), and directs the soil ...
Shell balances can be used in many situations. For example, flow in a pipe, the flow of multiple fluids around each other, or flow due to pressure difference. Although terms in the shell balance and boundary conditions will change, the basic set up and process is the same.