Search results
Results From The WOW.Com Content Network
In older distributors, adjusting the ignition timing is usually achieved through both mechanical advance and vacuum advance. Mechanical advance adjusts the timing based on the engine speed (rpm), using a set of hinged weights attached to the distributor shaft. These weights cause the breaker points mounting plate to slightly rotate, thereby ...
Fuel injected 283 cu in (4.6 L) engine installed in a 1959 Corvette. The 265 cu in (4.3 L) V8 engine was bored out to 3.875 in (98.43 mm) in 1957, giving it a 283 cu in (4.6 L) displacement. The first 283 motors used the stock 265 blocks. However, the overbore to these blocks resulted in thin cylinder walls. Future 283 blocks were cast to ...
For this article, a crate engine is defined as a fully-assembled engine that includes more than what is typically installed on a long block; the exact configuration will vary by vendor. It is also sometimes known as a "deluxe long block", which usually includes the fuel and intake system, distributor, oil pan, and ignition system.
Balance shaft engines do not have provisions for a mechanical fuel pump, unlike the non-balance shaft engines which retained the cast-in boss. For the 2007 model year, the distributor was eliminated in place of a coil-on-plug ignition system (using a 58x crankshaft position sensor based on the GEN IV LSx). This resulted in a redesigned timing ...
The contact breaker is operated by an engine-driven cam.On an engine with a distributor, the contact breaker can be found beneath the distributor cap.The position of the contact breaker is set so that it opens (and hence generates a spark) at exactly the optimum moment to ignite the fuel/air mixture.
The engine had MPFI (multi-port fuel injection), which gave slightly more power and better fuel economy, and two valves per cylinder. The engine had a bore and stroke of 4 + 1 ⁄ 4 in × 4 in (108.0 mm × 101.6 mm), producing 290 hp (216 kW) at 4000 rpm and 410 lb⋅ft (556 N⋅m) at 3200 rpm. It was used by Mercury Marine, named the ...
A resistance wire is used in the primary circuit. The distributors in EEC-III (and later) systems eliminate conventional mechanical and vacuum advance mechanisms. All timing is controlled by the engine computer, which is capable of firing the spark plug at any point within a 50-degree range depending on calibration.
Also installed on these export 2-barrel engines was a slightly hotter camshaft (244° duration rather than 240°), and a distributor with modified advance curves. This engine, rated at 160 bhp (162 PS; 119 kW), was popular in Central and South America, South Africa, Australia and New Zealand.