Search results
Results From The WOW.Com Content Network
A sawmill (saw mill, saw-mill) or lumber mill is a facility where logs are cut into lumber. Modern sawmills use a motorized saw to cut logs lengthwise to make long pieces, and crosswise to length depending on standard or custom sizes (dimensional lumber). The "portable" sawmill is simple to operate. The log lies flat on a steel bed, and the ...
After a tree is selected and felled, hewing can take place where the log landed or be skidded or twitched (skidded with a horse or oxen) out of the woods to a work site. . The log is placed across two other smaller logs near the ground or up on trestles about waist height; stabilized either by notching the support logs, or using a 'timber dog' (also called a log dog, [4] a long bar of iron ...
A felled and delimbed tree is cut into logs of standard sizes, a process called bucking. A logger who specialises in this job is a buck sawyer. Bucking may be done in a variety of ways depending on the logging operation. Trees that have been previously felled and moved to a landing with a log skidder are spread out for processing. While many of ...
A method for logs 16–19 in (41–48 cm) A method for logs over 19 in (48 cm) Quarter sawing or quartersawing is a woodworking process that produces quarter-sawn or quarter-cut boards in the rip cutting of logs into lumber. The resulting lumber can also be called radially-sawn or simply quartered.
Cut-to-length logging (CTL) is a mechanized harvesting system in which trees are delimbed and cut to length directly at the stump. [1] CTL is typically a two-man, two-machine operation with a harvester felling, delimbing, and bucking trees and a forwarder transporting the logs from the felling to a landing area close to a road accessible by ...
Cut-to-length logging is the process of felling, delimbing, bucking, and sorting (pulpwood, sawlog, etc.) at the stump area, leaving limbs and tops in the forest. Mechanical harvesters fell the tree, delimb, and buck it, and place the resulting logs in bunks to be brought to the landing by a skidder or forwarder .
Rip cuts are commonly made with a table saw, but other types of power saws can also be used, including a radial arm saw, band saw, and hand held circular saw.In sawmills the head saw is the first rip-saw a log goes through, which is sometimes a gang-saw, and then the cants may be resawn using other saws and then edged in an edger and sometimes cut to length by a crosscut saw.
Log splitting is the act of splitting firewood from logs that have been pre-cut into sections (rounds, bolts, billets [3]). This can be done by hand, using an axe or maul, or by using a mechanical log splitter. [4] When splitting a log by hand, it is best to aim for the cracks (called checks), if there are any visible. [5]