Ads
related to: current sensor interfacing with arduino circuit board
Search results
Results From The WOW.Com Content Network
The first Arduino board based on an ARM processor. Features 2 channel 12-bit DAC, 84 MHz clock frequency, 32-bit architecture, 512 KB flash and 96 KB SRAM. Unlike most Arduino boards, it operates on 3.3 V and is not 5 V tolerant. Arduino Yún [21] ATmega32U4, [22] Atheros AR9331 16 MHz, 400 MHz Arduino 68.6 mm × 53.3 mm [ 2.7 in × 2.1 in ]
Arduino (/ ɑː r ˈ d w iː n oʊ /) is an Italian open-source hardware and software company, project, and user community that designs and manufactures single-board microcontrollers and microcontroller kits for building digital devices.
Arduino RS232 Serial board - a predecessor with an ATmega8. The Arduino project started at the Interaction Design Institute Ivrea (IDII) in Ivrea, Italy.At that time, the students used a BASIC Stamp microcontroller, at a cost that was a considerable expense for many students.
The design of the saturable inductor current sensor is similar to that of a closed-loop Hall-effect current sensor; the only difference is that this method uses the saturable inductor instead of the Hall-effect sensor in the air gap. Saturable inductor current sensor is based on the detection of an inductance change. The saturable inductor is ...
Hall effect current sensor with internal integrated circuit amplifier. 8 mm opening. Zero current output voltage is midway between the supply voltages that maintain a 4 to 8-volt differential. The non-zero current response is proportional to the voltage supplied and is linear to 60 amperes for this particular (25 A) device.
Open source; Hardware compatible for SSI standard (synchronous serial interface); Cyclic reading of sensor data up to 64 bit per slave; Transmission of status data, parameter, measured temperature value, configuration description, etc.
The first Arduino board based on an ARM Processor. Features 2 channel 12-bit DAC, 84 MHz clock frequency, 32-bit architecture, 512 KB Flash and 96 KB SRAM. Unlike most Arduino boards, it operates on 3.3 V and is not 5 V tolerant. Arduino Yún [15] Arduino Yes ATmega32U4, [16] Atheros AR9331 16 MHz, 400 MHz Arduino
A Rogowski coil is a toroid of wire used to measure an alternating current I(t) through a cable encircled by the toroid. The picture shows a Rogowski coil encircling a current-carrying cable. The output of the coil, v(t), is connected to a lossy integrator circuit to obtain a voltage V out (t) that is proportional to I(t).