When.com Web Search

  1. Ads

    related to: what causes updrafts in water softener drain hose to flush hole in tub leak

Search results

  1. Results From The WOW.Com Content Network
  2. Air gap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Air_gap_(plumbing)

    In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained properly, the air gap works as described above, and prevents drain water from the sink from backing ...

  3. Water softening - Wikipedia

    en.wikipedia.org/wiki/Water_softening

    Brine draw: Water is directed through a jet pump, which pulls salt water from the brine tank, before the water and brine pass through the resin bed in the normal direction, if co-current, or in the reverse direction, if counter-current. [12] The output of this typically thirty-minute process is discarded through the drain hose.

  4. Internal erosion - Wikipedia

    en.wikipedia.org/wiki/Internal_erosion

    It is the second most common cause of failure in levees and one of the leading causes of failures in earth dams, [2] responsible for about half of embankment dam failures. [ 3 ] Internal erosion occurs when the hydraulic forces exerted by water seeping through the pores and cracks of the material in the dam and/or foundation are sufficient to ...

  5. Backflow - Wikipedia

    en.wikipedia.org/wiki/Backflow

    Backflow is a term in plumbing for an unwanted flow of water in the reverse direction. [1] It can be a serious health risk for the contamination of potable water supplies with foul water. In the most obvious case, a toilet flush cistern and its water supply must be isolated from the toilet bowl.

  6. Backwashing (water treatment) - Wikipedia

    en.wikipedia.org/wiki/Backwashing_(water_treatment)

    In some applications, air and water streams are simultaneously pushed upwards through the granular media followed by a rinse water wash. [3]: 213–4 Backwashing continues for a fixed time, or until the turbidity of the backwash water is below an established value. At the end of the backwash cycle, the upward flow of water is terminated and the ...

  7. Trap (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Trap_(plumbing)

    Maintaining the water seal is critical to trap operation; traps might dry out, and poor venting can suction or blow water out of the traps. This is usually avoided by venting the drain pipes downstream of the trap; by being vented to the atmosphere outside the building, the drain lines never operate at a pressure much higher or lower than ...