Ads
related to: elastomeric keypad
Search results
Results From The WOW.Com Content Network
Silicone rubber keypads (also known as elastomeric keypads) are used extensively in both consumer and industrial electronic products as a low cost and reliable switching solution. [ 1 ] Technology
Elastomeric connectors, also known by the registered trademark ZEBRA connectors, [1] consist of alternating conductive and insulating regions in a rubber or elastomer matrix to produce overall anisotropic conductive properties. The original version consisted of alternating conductive and insulating layers of silicone rubber, cut crosswise to ...
The internal structure of an elastomeric bearing consists of a three layers: a lower "pot" made of steel, which rests on the foundation or footing; a relatively thin elastomeric pad (a rectangle or disk shape) resting on the lower pot; and a steel plate loosely set on top of the elastomeric disk, on top of which the weight of the bridge rests.
An elastomer is a polymer with viscoelasticity (i.e. both viscosity and elasticity) and with weak intermolecular forces, generally low Young's modulus (E) and high failure strain compared with other materials. [1]
Silicone rubber keypad Electronic components are sometimes encased in silicone to increase stability against mechanical and electrical shock, radiation and vibration, a process called "potting". Silicones are used where durability and high performance are demanded of components under extreme environmental conditions, such as in space (satellite ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
2. Bang Bang Shrimp. Arkansas, Kansas, Louisiana, Nebraska . Crispy shrimp tossed in a creamy, garlicky, sweet, and spicy sauce never fails. I hope the good people of Arkansas, Kansas, Louisiana ...
In its uncured state, silicone rubber is a highly adhesive gel or liquid. To convert it to a solid, it must be cured, vulcanized, or catalyzed.This is normally carried out in a two-stage process at the point of manufacture into the desired shape, and then in a prolonged post-cure process.